- Hewlett-Packard Printer User Manual

Unpacking and Assembly 1-7
Unpacking and
Assembly
This procedure assumes that the printer is in its final location.
See the Site Preparation Guide for moving and unpacking hints.
WARNING
The printer is too heavy to be lifted safely by one
person. At least three persons are required to lift the
printer.
WARNUNG
Der Drucker ist zu schwer für eine Person. Mindes-
tens 3 Personen sind erforderlich um den Drucker
anzuheben.
Note
If you will be installing a ColorSpan Print Server, set
it up now and power it on. This will allow the server
to perform its automatic one-time new system check
while you unpack and assemble the printer.
Required Tools ◆ Claw hammer to remove the fasteners from the triwall corru-
gated outer box from the pallet
◆ #3 Phillips head screwdriver
◆ #2 Phillips head screwdriver
◆ Socket wrench with 10 mm socket
◆ Bubble level
It is recommended that three persons be available to lift the
printer onto the stand and a fourth person to assemble the
printer to the stand. The remainder of the installation can be
performed by one person.
Unpacking 1. Examine the shipping packaging for shipping damage.
The printer is delivered to your site packed in one cardboard
box, attached to a wooden pallet. Report any damage or
apparent rough handling immediately to the shipper.
For the DisplayMaker 72
SR, the input and output tables are
shipped in a separate box.
2. Cut and remove the bands that secure the box to the pallet.
3. Remove the nails that attach the box to the pallet.
4. Open the top flaps of the box.