- Hewlett-Packard Printer User Manual

EN
Chapter 7 149
Cleaning the toner density sensor
The toner density sensor should be
cleaned whenever the imaging drum is
replaced or whenever the control panel
message
DENSITY SENSOR OUT OF
RANGE
displays.
CAUTION
To avoid scratching the sensor, do not
clean it with any paper products.
To clean the toner density
sensor
1 Open the lower front drawer and
remove the cleaning brush mounted
inside. Then close the drawer.
2 Pull open the top front drawer.
3 Remove the imaging drum by the
blue handle.
4 Use the cleaning brush to remove all
dust and toner particles from the
sensor. as illustrated.
1
3
4
2