- Hewlett-Packard Color LaserJet Printer Owner's Manual
Table Of Contents
- Printer basics
- Control panel
- I/O configuration
- Printing tasks
- Managing the printer
- Color
- Maintenance
- Managing supplies
- Supplies life
- Approximate replacement intervals for supplies for the hp color LaserJet 3500 series printer
- Approximate replacement intervals for supplies for the hp color LaserJet 3700 series printer
- Checking the print cartridge life
- Print cartridge storage
- HP print cartridges
- Non-hp print cartridges
- Print cartridge authentication
- HP fraud hotline
- Replacing supplies and parts
- Cleaning the printer
- Configuring e-mail alerts
- Managing supplies
- Problemsolving
- Basic troubleshooting checklist
- Control panel message types
- Control panel messages
- Paper jams
- Common causes of paper jams
- Clearing paper jams
- Paper handling problems
- Troubleshooting information pages
- Printer response problems
- Printer control panel problems
- Color printing problems
- Incorrect printer output
- Software application problems
- Print quality troubleshooting
- Print quality problems associated with paper
- Overhead transparency defects
- Print quality problems associated with the environment
- Print quality problems associated with paper jams
- Print quality problems associated with toner buildup inside the printer
- Print quality troubleshooting pages
- Calibrating the printer
- Supplies and accessories
- Service and support
- Printer specifications
- Regulatory information
- Working with memory and print server cards
- Glossary
- Index
Setting the idle timeout
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO 1.
7. Press
to select EIO 1.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to select CONFIG METHOD.
11. Press
to highlight MANUAL.
12. Press
to select MANUAL.
13. Press
to highlight MANUAL SETTINGS.
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight IDLE TIMEOUT.
16. Press
to select IDLE TIMEOUT.
17. Press the
or arrow to increase or to decrease the number of seconds for the idle
timeout.
18. Press
to save the idle timeout.
19. Press M
ENU
to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O SUBMENU.
5. Press
to select I/O SUBMENU.
6. Press
to highlight EIO 1.
7. Press
to select EIO 1.
8. Press
to highlight LINK SPEED.
9. Press
to select LINK SPEED.
10. Press
to highlight the desired link speed.
11. Press
to select the desired link speed.
12. Press M
ENU
to return to the Ready state.
56 Chapter 3 I/O configuration ENWW