- Hewlett-Packard Color LaserJet Printer Owner's Manual
Table Of Contents
- Printer basics
- Control panel
- I/O configuration
- Printing tasks
- Managing the printer
- Color
- Maintenance
- Managing supplies
- Supplies life
- Approximate replacement intervals for supplies for the hp color LaserJet 3500 series printer
- Approximate replacement intervals for supplies for the hp color LaserJet 3700 series printer
- Checking the print cartridge life
- Print cartridge storage
- HP print cartridges
- Non-hp print cartridges
- Print cartridge authentication
- HP fraud hotline
- Replacing supplies and parts
- Cleaning the printer
- Configuring e-mail alerts
- Managing supplies
- Problemsolving
- Basic troubleshooting checklist
- Control panel message types
- Control panel messages
- Paper jams
- Common causes of paper jams
- Clearing paper jams
- Paper handling problems
- Troubleshooting information pages
- Printer response problems
- Printer control panel problems
- Color printing problems
- Incorrect printer output
- Software application problems
- Print quality troubleshooting
- Print quality problems associated with paper
- Overhead transparency defects
- Print quality problems associated with the environment
- Print quality problems associated with paper jams
- Print quality problems associated with toner buildup inside the printer
- Print quality troubleshooting pages
- Calibrating the printer
- Supplies and accessories
- Service and support
- Printer specifications
- Regulatory information
- Working with memory and print server cards
- Glossary
- Index
![](/manual/hp/3500-3700/hewlett-packard-color-laserjet-printer-owners-manual/images/img-112.png)
Note
If the old transfer unit was not at end-of-life when it was replaced (for example, if it was
damaged), the transfer unit count must be reset using the printer control panel.
To reset the transfer unit count
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight RESETS.
5. Press
to select RESETS.
6. Press
to highlight RESET SUPPLIES.
7. Press
to select RESET SUPPLIES.
8. Press
to highlight NEW TRANSFER KIT.
9. Press
to select NEW TRANSFER KIT.
10. Press
to highlight YES.
11. Press
to select YES.
The transfer unit count is reset and the printer is ready to use.
Replacing the fuser and pickup roller
Replace the fuser and pickup roller when the printer control panel displays the message
REPLACE FUSER KIT. The image fuser kit contains a replacement fuser and a Tray 2
pickup roller for this printer. After replacing the fuser, you must also replace the pickup roller.
Instructions for replacing the pickup roller follow the instructions for replacing the fuser.
ENWW Replacing supplies and parts 117