User's Manual

Environmental control system 54
Configure
You can see the Configure menu when you enter the customer-level password. This menu allows you to
configure alarm setpoints and Adiabatic control settings in the ECS system.
The following menus are available when you select the Configure menu:
• Control settings (on page 54)
• HMI settings (on page 55)
CAUTION: Making any change to the ECS in the customer-level area can cause the AHU to fail.
Only authorized, qualified, and trained personnel should change configuration settings in the
customer-level area of the ECS. Any changes to the configuration settings in the customer-level
area might void your warranty.
Control settings
IMPORTANT: You can only access this menu after you enter a customer-level password.
IMPORTANT: The ECS parameters must only be set by qualified service personnel.
The Control Settings menu displays the Adiabatic Control Settings for IT section A and IT section B. The
following settings can be configured from the Adiabatic Control Settings screen: