user manual

Required Tools
Hardware Review
All screws used in the printer are Phillips head, which require a
Phillips screwdriver. Figure 6-1 shows the difference between a
Phillips and a Pozidriv screwdriver. Note that the Phillips tip has
more beveled surfaces.
Caution
Use of a Pozidriv screwdriver will damage the
screw heads. Use Phillips only.
QTY TOOL
1 #2 Magnetized Phillips Screwdriver (6-inch shaft)
1 Small Needle Nose Pliers
1 Small Flat-head Screwdriver (6-inch shaft)
1 5mm Nut driver
Table 6-1 Required Tools
PosidrivPhillips
Figure 6-1 Comparing Phillips and Pozidrive Screws
6-2 Removal and Replacement