user manual

Table 3-8. Programming Language Comparison (continued)
Description
Set remote knob
Request status byte mask
Reset sweep
Number of steps in
a stepped sweep
Swap network analyzer
channels
Test HP-IB interface
Sets sweep time lower limit
Take sweep
Instrument State
Instrument preset
Local instrument control
Markers [n] is 1 to 5, 1 is default
Turn on and set marker
Turn off frequency marker
Enable Ml-M2 sweep
Disable Ml-M2 sweep
Move start->Ml stop->M2
Enable delta marker
Disable delta marker
Move marker to
center frequency
Turn off all markers
Turn on amplitude markers
Turn off amplitude markers
Network Analyzer
Language
RB
RE <num>,RM <num>
RS
SN <num>
SW <110>
TI <num>
TL <num>time-suffix
TS
SCPI Language
*SRE <num>, *SRE?
*ESE <num>, *ESE?’
ABOR
SWE:POIN <num>
DIAG:TINT? <num>
SWE:TIME:LLIM <num>[time-suffix]
TSW;*WAI
IP
LOCAL 7XX
Mn <num>freq-suffix
MnMO
MPl
MPO
SHMP
MD1
MD0
MC
SHMO
AK1
AK0
SYST:PRES
LOCAL 7XX
(XX=Source HP-IB address)
MARK[n]:FREQ
<num>[freq-suffix]
STAT ON
MARK[n] OFF
SWE:MARK:STAT ON
SWE:MARK:STAT OFF
SWE:MARK:XFER
MARK[n]:DELT? <num>,<num>
MARK OFF
MARK[n]:FREQ?;
:FREQ:CENT <response>[freqsuffix]
MARK:AOFF
MARK[n]:AMPL ON
;AMPL:VAL <num>[DB]
MARK:AMPL OFF
Specifications
INSTALLATION 3-27