Assembling & Installation Instructions

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured.
You may wrap the connections with electrical tape. If
your outlet box has a ground wire (green or bare copper)
connect fixture’s ground wire to it. Otherwise attach the
bare copper fixture wire to the green ground screw on the
mounting plate.
2.Tuck the wire connections neatly into the wall junction
box.
Installation (see fig.1)
1. Disconnect power at main electrical panel before
installation.
2. Carefully unpack new fixture and lay all the parts on a
clear surface.
3. Thread the two mounting screws about 1/4” into the
pre-drilled holes in the mounting plate, spaced about the
same distance apart as the holes in the fixture back plate.
Attach the mounting plate to the junction box using two
junction box screws. The side of the mounting plate
marked “GND” must face to out.
The junction box is
not included.
4. Guide fixture wires through hole in center of mounting
plate. Follow wiring instructions carefully (see fig.2)
5. Attach the back plate(E) over the mounting plate, aligning
the back plate holes with mounting screw, then lock it
securely with ball nuts(D).
6. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
7. Raise the shade(F) to the back plate(E), aligning the top
holes of shade with the top back plate holes, lock it
securely with the ball nuts(G).
8. Raise the end grapnel of the crystal cluster(A) hooked the
top cover of the shade(F); Raise the end grapnel of the
crystal cluster(B,10pcs) hooked the middle ring of the
shade(F). Raise the end grapnel of the crystal cluster(C)
hooked the outer ring of the back plate(E), crystal cluster
(B,10pcs) hooked the inside ring of the back plate(E).
Page 1 of 1
Fig.1
D
F
G
Completion
of assembly
Ground Wire
wire
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT
For Wall Mount Light Fixture