Installation Instructions

ManualsBrandsHouse of Hampton ManualsBathroom Vanity LightingAranda Crystal 3-Light Vanity Light

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Mounting Hardware

• Crossbar plate

• 3 x Crystal shades

• LED

APPLICATION

Wall Fixture

IMPORTANT SAFETY INSTRUCTIONS

MESURES DE SECURITE A RESPECTURE

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

Read all instructions

Do not install this fixture in hazardous locations.

N'installez pas cet appareil dans des emplacements dangereux.

Do not install any fixture assembly closer than 6 inches from any

curtain or similar combustible material.

Laisser une distance d’au moins 6 pouces entre ce luminaire et la toute

surface combustible.

"WARNING Risk of Fire and Electric Shock."

“CAUTION: Risque d’ Incendie et de Choc Electriques.”

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and the U.S. National Electrical Codes (NEC). These fixtures are

intended for mounting to a standard 4” metal octagon outlet box.

The box must be directly supported by the building structure and U.L.

Recognized.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

CERTIFICATION: cETLus DAMP

Before assembling your fixture, please make sure thatyou carefully read

through this instruction sheet. Save this instruction sheetand refer to it

when additions to or changes in the fixture configuration are made.

Lisez attentivement ce manuel d’instructions. Enregistrer cette feuille

d'instructions et de s'y référer lorsque les ajouts ou changements dans

la configuration de montage sont faites.

CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH

CIRCUIT CONDUCTOR.

CONSULTER UN ELECTRICIEN QUALIFIE POUR VOUS ASSURER QUE LES

CONDUCTEURS DE LA DERIVATION SONT ADEQUATS

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONTSTRUCTION

AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

CE PRODUIT DOIT ETRE INSTALLE SELON LE CODE D’INSTALLATION PERTINENT,

PAR UNE PERSONNE QUI CONNAIT BIEN LE PRODUIT ET SON FONCTIONNEMENT

AINSI QUE LES RISQUES INHERENTS

Summary of content (2 pages)

PAGE 1
CERTIFICATION: cETLus DAMP INSTALLATION INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS MESURES DE SECURITE A RESPECTURE Before assembling your fixture, please make sure that you carefully read through this instruction sheet. Save this instruction sheet and refer to it when additions to or changes in the fixture configuration are made. Lisez attentivement ce manuel d’instructions.
PAGE 2
CERTIFICATION: cETLus DAMP 1 MOUNT CROSSBAR AND CONNECT THE WIRES If there is an existing fixture remove it. Expose the supply wires from the J-box. Install the crossbar plate and mount it to the J-Box with the supplied screws. Gently pull the supply wires through the hole in the crossbar plate. Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wire to the white fixture wire. Secure with the supplied wire nuts.