Operation Manual

33
EN
Notes:
Optimum performance levels when using the “Fast" and
"Express”cyclescanbeachievedbyrespectingthespecified
number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative
ENtestingconditions,pleasesendanemailtothefollowing
address:[e-mail]
Special wash cycles
and Options
Wash options*
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle (seeTableofwashcycles) , the
correspondingsymbolflashesrapidly3times.
If an option is selected which is not compatible with another
(previouslyselected)option,itwillflash3timesandswitch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Multi-functional tablets Option (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the
MULTI-FUNCTIONALTABLETSbutton;thecorresponding
symbol will light up. If the button is pressed again, the option
will be deselected.
The “Multi-functional tablets” option results in a
longer wash cycle.
Delayed start Option
It is possible to delay the start time of the cycle by a
period of time between 1 and 24 hours:
1.Select the desiredwashcycle and anyotheroptions
required;presstheDELAYEDSTARTbutton.Theindicator
light will go on. Use the same button to select when the wash
cyclewillstart(h01,h02etc.)
2.ConfirmtheselectionusingtheSTART/PAUSEbuttonto
start the countdown.
3.Oncethistimehaselapsed,theDELAYEDSTARTindicator
light goes off and the wash cycle begins.
TodeselecttheDELAYEDSTARToption,presstheDELAYED
STARTbuttonuntilthetextOFF appears.
The Delayed Start function cannot be set once a wash
cycle has started.
Half load Option using the upper or lower rack
If there are not many dishes to be washed, a half
load cycle may be used in order to save water,
electricityanddetergent.Selectthe wash cycle and then
presstheHALFLOADbutton:theindicatorcorresponding
to the chosen rack lights up and the wash cycle starts only
in the upper or lower rack.
Remember to load the upper or lower rack only, and
to reduce the amount of detergent accordingly.
* Only available in selected models.