User's Manual

Restoring the original coding.
1. Open the battery compartment cover -
a small button on the circuit board can
be accessed.
2. Take a blunt object and gently press and
hold button
O
a .
Note:
Do not use any sharp objects. Excessive
pressure can destroy the button.
3. Press and hold the control button you
wish to code – the LED on the trans-
mitter flashes slowly for max. 4 seconds.
4. If the small button is held down until the
slow flashing phase ends, the control
button will then be re-coded with the
original factory code and the LED starts
flashing rapidly.
5. Close the battery compartment cover.
6. Re-programme the receivers.
Re-coding with another unique code not
pre-programmed at the factory.
1. Open the battery compartment cover -
a small button on the circuit board can
be accessed.
2. Take a blunt object and gently press and
hold button
O
a .
3. Press and hold the control button you
wish to code – the LED on the trans-
mitter flashes slowly for max. 4 seconds.
4. If the small button is released before the
slow flashing phase ends, the control
button you wish to code will be re-coded
with another code and the LED immedia
tely starts flashing rapidly.
5. Close the battery compartment cover.
6. Re-programme the receivers
7
ENGLISH
Fernst/HF-1 Set 436014-neutra 18.12.2001 14:18 Uhr Seite 7