User's Manual

Note:

Before installing the FCT 10, check out the location where you wish to

install it in order to ensure that the radio signal can be received by the

receivers.

The FCT 10 is powered by a proprietary 9V block battery. Successful entries

and alterations are stored and retained even in the event of a voltage loss.

With ten freely selectable 2 to 6-digit access codes just as many functions

can be activated by radio signal; i.e. with an FCT 10 it is possible to actuate

by radio signal and impulse, for example, up to ten door operators.

In addition, a direct function - not protected by an access code - is available,

with which, for example, and also by radio signal (together with a correspon-

ding receiver) a bell or outdoor lighting can be operated.

2 Installation

(see figure 1)

3 Important terminology

Start-up code (IB code)

This is an 8-digit number code which is required in order to protect the unit

against unauthorized programming (➜ theft protection). Only using this 8-digit

number code can the access codes be entered, altered or deleted. In addition,

entry of this code is also required after inserting the battery (e.g. when starting

up) or on changing the battery in order to activate the unit's functions (➜ theft

protection). In the ex factory state this code is preset with "12345678". The

user should replace this preset code with his own personal IB code to ensure

that no-one else can gain access to the programming and hence the functions

of the unit. If the personal IB code gets lost, then the unit can only be made

to work again by undergoing a so called factory reset in the factory, after

which the unit is returned to the ex factory state.

HÖR/Funkcodetaster FCT10/4Spr. 18.12.2001 14:19 Uhr Seite 5