Installation Manual

Français : voir la page 17 • Español: vea la página 32
13 69-2090EFS—07
Replacing system components
Thermostat
To replace a thermostat, install batteries and follow the procedure on page 4
to link it to the wireless network. If necessary, modify settings as needed (see
tables on pages 7-9).
Remote control & outdoor sensor
To replace a remote control or outdoor air sensor, install batteries and
follow the procedure on page 5 to link it to the wireless network.
TrueZONE panel & wireless adapter
After installing a new zone panel or wireless adapter, you must re-set the
thermostat and remote control to communicate with the new equipment, as
described below.
At the thermostat:
1 Press and hold the fan and s buttons for 3 seconds.
2 Press back twice to display Function 39 (wireless setup).
3 Press t to change Function 39 setting to 0 (disconnect from old
equipment).
4 Follow the procedure on page 4 to link to new equipment.
At the remote control:
1 Press and hold the blank space (or arrow if present) in the lower right
corner of the screen until the display changes (about 3 seconds).
2 Press remove , then yes to disconnect from old equipment.
3 Follow the procedure on page 5 to link to new equipment.
Press and hold for
about 3 seconds