Install Instructions

ManualsBrandsHoneywell ManualsHeating Supplies1/2" NPT Male Union Two-Way Unitary Valve (.63 Cv)

Table Of Contents

VP525A,C

Pneumatic Radiator Valve

INSTALLATION INSTRUCTIONS

2-1/4 DIAMETER (57)

AIR CONNECTION

FOR1/4 IN. (6 mm)

O.D. PLASTIC TUBING

AIR CONNECTION

FOR1/4 IN. (6 mm)

O.D. PLASTIC TUBING

COVER FASTENER COVER FASTENER

BEFORE INSTALLATION

This normally-open, single-seated, straight-through,

pneumatic valve provides two-position or proportional control

of two-pipe hot water or steam systems.

The valve can be installed in any position. The direction of

flow must be in the same direction as the arrow cast on the

valve body.

Refer to Fig. 1 for dimensions to determine the space required

for proper installation. Be sure to allow enough clearance

around the actuator top for servicing after installation.

1-1/2

(38)

1-1/2 in. (38 mm) MINIMUM CLEARANCE TO REMOVE

ACTUATOR. 2 1/2 in. (63 mm) MINIMUM CLEARANCE

TO FACILITATE STRAIGHT ON TUBING CONNECTION.

IF CLEARANCE IS LESS THAN 2 1/2 in. (63 mm)

USE AN ELBOW.

SPECIFICATIONS

Body Pressure Rating: 150 psi (1034 kPa) maximum.

Controlled Medium Temperature (maximum):

VP525A: 180°F (82°C) maximum.

VP525C: 240°F (116°C) maximum.

Maximum allowable difference (alternating hot and cold

water): 140°F (78K).

Maximum Safe Air Pressure: 30 psi (207 kPa).

Maximum Differential Pressure for Quiet Service:

Water: 20 psi (138 kPa).

Steam (VP525C): 10 psi (69 kPa).

Close Off Ratings:

VP525A: See Fig. 2.

VP525C: See Fig. 3.

1-1/2

(38)

BODY STYLE SIZE NPT

B C D E

STRAIGHT THRU œ

MALE UNION OUTLET

1/2

3-1/2 (90)

1-3/8 (35)

2-1/2

(63)

1-3/8 (35)

3/4

(19)

3/4

3-1/2 (90)

1-3/8 (35)

(76)

1-5/8 (41)

1-1/8

(29)

ANGLE œ MALE

UNION OUTLET

1/2

3-1/4 (83)

1 (25)

2-5/8

(66)

1-1/8 (29)

3/4

3-1/8 (80)

1 (25)

(76)

1-1/4 (32)

M16449A

Fig. 1. VP525 threaded union body dimensions in in. (mm).

® U.S. Registered Trademark

95-5544EF-1

Summary of content (8 pages)

PAGE 1
VP525A,C Pneumatic Radiator Valve INSTALLATION INSTRUCTIONS BEFORE INSTALLATION SPECIFICATIONS This normally-open, single-seated, straight-through, pneumatic valve provides two-position or proportional control of two-pipe hot water or steam systems. Body Pressure Rating: 150 psi (1034 kPa) maximum. The valve can be installed in any position. The direction of flow must be in the same direction as the arrow cast on the valve body. Refer to Fig.
PAGE 2
VP525A,C PNEUMATIC RADIATOR VALVE INSTALLATION Threaded Union Body Version Typical applications of straight-through and angle pattern union connected valves are shown in Fig. 4. The direction of flow must be toward the union connected end (the same direction as the arrow cast on the valve body). Use proper piping methods when installing the threaded union body to prevent distortion of the valve body (see Fig. 5).
PAGE 3
VP525A,C PNEUMATIC RADIATOR VALVE EXCESS DOPE MAY BLOCK DISC OFF VALVE SEAT LOOSE CHIPS 2 THREADS CLEAN – MODERATE AMOUNT OF DOPE PIPE SIZE EFFECTIVE LENGTH OF THREADS 1/2 in. 1/2 in. (13 mm) 3/4 in. 9/16 in. (14 mm) RIGHT – FULL THREAD (SEE TABLE) WRONG – TOO MANY THREADS RIGHT WRONG VISE MAY SQUEEZE VALVE SEAT OUT OF ROUND. IF VISE IS USED, GRIP ONLY THE HEX NEXT TO PIPE BEING INSERTED.
PAGE 4
Automation and Control Solutions Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 95-5544EF–1 Honeywell Limited-Honeywell Limitée 35 Dynamic Drive Scarborough, Ontario M1V 4Z9 B.B. Rev. 12-02 Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. www.honeywell.
PAGE 5
Vanne pneumatique pour radiateur VP525A et C NOTICE D'INSTALLATION AVANT D'INSTALLER CE PRODUIT… CARACTÉRISTIQUES TECHNIQUES Les VP525 A et C sont des vannes pneumatiques normalement ouvertes à passage direct et à simple siège qui assurent la commande tout ou rien ou la régulation proportionnelle des systèmes à vapeur ou à eau chaude à deux canalisations. Pression nominale maximale du corps : 1034 kPa (150 psi). Cet appareil peut être installé dans n'importe quelle position.
PAGE 6
VANNE PNEUMATIQUE POUR RADIATEUR VP525A ET C INSTALLATION Corps de vanne avec raccord union fileté Les applications typiques des vannes à corps droit ou en équerre avec raccord union sont illustrées à la Fig. 4. Le fluide doit s'écouler vers l'extrémité du raccord union, c'est-à-dire dans le sens indiqué par la flèche sur le corps de la vanne. Installer le raccord fileté selon les méthodes de tuyautage recommandées pour empêcher le gauchissement du corps de la vanne. (Voir la Fig. 5).
PAGE 7
VANNE PNEUMATIQUE POUR RADIATEUR VP525A ET C UNE TROP GRANDE QUANTITÉ DE MASTIC RISQUE D'OBSTRUER LE SIÊGE DE VANNE TAILLE LONGUEUR DE DU TUYAU FILETAGE EFFICACE ÉCLATS 1/2 po 13 mm (1/2 po) 3/4 po 14 mm (9/16 po) CORRECT – BONNE LONGUEUR DE FILETAGE (VOIR LE TABLEAU) INCORRECT – FILETAGE TROP LONG CORRECT INCORRECT L'ÉTAU POURRAIT ÉCRASER LE SIÊGE DE VANNE. AVEC L'ÉTAU, SERRER SEULEMENT L'ÉCROU HEXAGONAL AU BOUT DU TUYAU INSÉRER.
PAGE 8
Solutions de régulation et d‘automatisation Honeywell 1985 Douglas Drive North Golden Valley, MN 55422 95-5544EF–1 Honeywell Limited-Honeywell Limitée 35, Dynamic Drive Scarborough (Ontario) M1V 4Z9 B.B. Rév. 12-02 Imprimé aux États-Unis sur du papier recyclé contenant au moins 10 % de fibres post-consommation. www.honeywell.