Thermostat User Manual

VisionPRO

TH8000 Series

69-2400EFS—03

ENGLISH

In case of difficulty

Heating or

cooling system

does not respond

• Press SYSTEM to set system to Heat. Make sure the temperature is set higher than the

Inside temperature.

• Press SYSTEM to set system to Cool. Make sure the temperature is set lower than the

Inside temperature.

• Check circuit breaker and reset if necessary.

• Make sure power switch at heating & cooling system is on.

• Make sure furnace door is closed securely.

• If “Wait” is displayed, the compressor protection timer is on. Wait

5 minutes for the system to restart safely, without damaging the

compressor (see page 15).

Display shows

Fan Auto and On

or Auto and Circ

at the same time

• This is normal operation. Auto indicates the thermostat is following the

programmed fan setting. If Auto and On is shown, the fan is scheduled

for “On” during this period (see page 7).