Door User Manual

VISIOCAM

3 69-2108EFS—01

Pre-installation setup

Charge the receiver batteries

1. Remove the battery isolating tab at the rear of the portable

receiver.

2. Place the receiver onto the charging base and plug the

charging base into a suitable mains socket.

The battery indicator flashes slowly if this is

the first time the unit has been powered up; the

chime tunes play once the batteries have enough

power.

Before the next step, leave the unit to charge

for at least three hours so that the batteries

have enough power for the LCD screen. The

receiver takes about 12 hours to be fully charged.

Note that the charging base and rear of the

receiver will get warm in use: this is normal.

Program the door camera into the receiver

Ensure the door camera and receiver are sepa-

rated by at least 6 ft. (2 m).

To program the door camera into the receiver,

press and hold the call button on the door cam-

era until the receiver responds with a tune and

displays the image captured by the camera.

Once the door camera has been programmed

into the receiver, the receiver remains active in

program mode for approximately two minutes.

Note: You can select another tune by pressing

the ‘ ’ button.

69-2108EFS_A.indd 3 11/30/2007 1:51:45 PM