Installation Guide

6
2.1 Install batteries in RedLINK
accessories.
• Portable Comfort Control
• Wireless Outdoor Sensor*
• Wireless Indoor Sensor*
• Wireless Entry/Exit Remote*
• Wireless Vent and Filter Boost
Remote*
* Requires setup. See Installer
Setup options in Step 3.4.
2.2 Connect gateway to internet and
connect to power.
2.2a Connect RedLINK Internet
Gateway to router or modem
with Ethernet cable (RJ45).
2.2b Connect gateway’s power cord
to an electrical outlet that is
not controlled by a wall switch.
NOTE: If the thermostat is wired
directly to the equipment, 24VAC (C
wire) is required to connect RedLINK
accessories. Turn on 24VAC before
performing initial setup in Step 3.
Initial setup options define the type of system you are installing:
• Residential or commercial
• Non-zoned or zoned
• Used with or without an Equipment Interface Module (THM5421)
• Used with or without the TrueZONE Wireless Adapter (THM4000)
3.1 Follow prompts on the screen to
select the appropriate options.
NOTE: If you are connecting the
thermostat to the TrueZONE Wireless
Adapter (THM4000), refer to the
TrueZONE instructions to link the
thermostat and RedLINK accessories.
Then go to Step 3.4.
3.2 When you see the prompt Connect
RedLINK Accessories? Touch No or Yes.
• If you select No, continue to Step 3.4.
• If you select Yes, you will be prompted
to Press Connect on New Accessories.
Continue to Step 3.3.
2.2a
2.2b
MCR33970
Connect RedLINK
Accessories?
APPLICATION
residential
2
Powering optional RedLINK accessories
3
Performing initial setup