Operation Manual

20
69-1120
LEVEL
M1714A
WALL
WIRES THROUGH
WALL OPENING
WALL ANCHORS (2)
MOUNTING
PLATE
MOUNTING
SCREWS
(
2
)
M1718
Step 7. Mount Thermostat Mounting Plate
❑ Position mounting plate on wall. Use level to
make sure mounting plate is level. Use a
pencil to mark the two mounting holes.
❑ Remove mounting plate from wall, and drill
3/16-inch holes in wall (if drywall) as
marked. For firmer material such as plaster
or wood, drill
7/32-inch
holes.
Gently
tap
anchors
(provided)
into
drilled holes
until flush
with the wall.
❑ Reposition mounting plate over holes,
pulling wires through wiring opening.
Loosely insert two mounting screws into
holes.
❑ Level for appearance only; thermostat will
function properly even when not level.
Tighten mounting screws.