Install Instructions

ManualsBrandsHoneywell ManualsHVAC SuppliesElectronic Universal Controller, 2SPDT, 2 Analog outputs, 2 sensor inputs

Table Of Contents

T775U SERIES 2000 CONTROLLER 2. PROGRAMMING OUTPUTS (MOD AND RELAY) WITH NO RESET

62-0255–03 24

Fig. 57. Setup Exit.

1.4. Exiting Setup

Press the HOME button to exit Setup mode and return to

the home screen display.

Use the S and T buttons to highlight EXIT from the menu

and press the X button.

This completes the Setup procedure.

2. PROGRAMMING OUTPUTS (MOD

AND RELAY) WITH NO RESET

The T775U can be programmed for Reset or No Reset.

From the factory, the T775U is programmed for No Reset.

This section describes the steps necessary to program

the controller for No Reset.

NOTE: For applications where Reset is not used, only

one sensor (Sensor A) is available for use.

Fig. 58. Program Menu.

2.1. Entering Program Mode

Press the MENU button, then select PROGRAM and

press the X button to view the Program menu.

Fig. 59. Program Menu - No Reset.

2.1.1. Program Menu for Outputs with No Reset

From the Program menu, select MOD1 to view the

parameters.

NOTE: For Relays, DIFFRNTL replaces THROT RNG.

NOTE: The Setback parameter displays only if schedul-

ing is enabled (see Fig. 47 on page 20) or the DI

Option is set to Setback. (see Fig. 49 on

page 21).

Continue with “2.1.2. SETPOINT”.

SETUP

SENSORS

OUTPUTS

EXIT

M24619

PROGRAM

MOD 1

MOD 2

RELAY 1

RELAY 2

EXIT

M24567

PROGRAM

MOD 1

PROGRAM

MOD 1

SETPOINT

THROT RNG

ACTION

SETBACK

EXIT

M24580