Product Overview

ManualsBrandsHoneywell ManualsCommercial Thermostats & Controls20K LCD Temp Wall Module w/ Selectable Setpoint/Override

7$%',*,7$/:$//02'8/(6

5 74-3097

6HW)DQ0RGH

The UNIT ENABLE button switches the fan mode between

AUTO and MANU OFF:

AUTO

(fan speed from controller)

MANU OFF

(fan off)

With this setting, depending

on configuration, the display

may also read:

+XPLGLW\'LVSOD\

If applicable, the humidity is indicated by the bargraph at the

top of the LCD. Each segment of the bargraph represents 4%

of relative humidity:

127( Humidity display is not available with fan control.

Humidity mode

(e.g., left 12 segments ON =

50% relative humidity)

6HW%\SDVV2FFXSDQF\0RGH'LVSOD\

The bypass function can be used to override the control

algorithm generated by the controller (e.g., for an event after

normal office hours, or for a room that is known not to be

used).

The status of the occupancy mode can be seen from the

sun-, moon-, and snowflake symbols. The following LCD

behaviors are possible, depending on configuration (see

T7560A,B Installation Instructions, form 95-7620 for

configuration options):

2FFXSDQF\PRGHGLVSOD\IRU([FHO/&'VLJQDOLQJ

([FHOVHWWR/&'B',63/$<ZLWK)&8+<'&+&RQO\

VHH7$%,QVWDOODWLRQ,QVWUXFWLRQVIRUP

Effective Occupancy or Bypass mode

(SUN continuously ON)

Effective Standby mode; generated by

time program

(HALF-SUN continuously ON)

Effective Unoccupancy mode

(MOON continuously ON)

Unit Off, No Frost Protection

(OFF without snowflake)

Unit Off, With Frost Protection

(OFF WITH SNOWFLAKE)

Override Standby mode (from central)

(HALF-SUN FLASHING)

Wink mode (network ID sent)

(SUN/MOON/SNOWFL. FLASHING)

(Only with FCU, HYD, CHC)

Press the BYPASS button to set the desired mode:

• Press and release BYPASS button

to activate Override Occupancy or Bypass mode

• Press and hold BYPASS button for at least 5 sec.

to activate Override Unoccupancy mode

• Press and release BYPASS button again

to return to normal mode

127( Pressing the BYPASS button for more than 5

seconds sends the NEURON

ID of the connected

Excel 10 controller via the L

ONWORKS

network.

Override Occupancy or Bypass mode

(SUN FLASHING)

Override Unoccupancy mode

(MOON FLASHING)

2YHUULGHPRGHGLVSOD\IRU([FHO/('VLJQDOLQJ

([FHOVHWWR/('B29(55,'(

Off Conditions, No Override, Overr.

Occupancy, Overr. Standby (NO

SYMBOLS)