User manual

2 Honeywell Sensing and Control
SMART Position Sensor, 35 mm, 75 mm and
225 mm Linear Configurations
ISSUE 4
50046793
Table 1. Specications
Characteristic Component Parameter
35 mm 75 mm 225 mm
analog
(SPS-L035-LATS)
analog
(SPS-L075-HALS)
analog
( SPS-L075-HALS)
digital
(SPS-L225-HDLS)
Sensing range
sensor only
0 mm to 35 mm
[0 in to 1.38 in]
0 mm to 75 mm
[0 in to 32.95 in]
0 mm to 225 mm
[0 in to 8.86 in]
Resolution 0.04 mm [0.0016 in] 0,05 mm [0.002 in] 0,14 mm [0.0055 in] 0,0035 mm [0.000137 in]
Supply voltage 4.75 Vdc to 5.25 Vdc 6 Vdc to 24 Vdc
Output 0.55 Vdc to 4.15 Vdc 0 Vdc to 5 Vdc RS 232-type digital
Supply current 20 mA max. 32 mA max. 34 mA max. 88 mA max.
Linearity
1
±1.0% full scale output ±0.4% full scale output
Reverse polarity -5 V 26.4 V at 125 °C [257 °F]
Sensitivity 103 mV/mm typ. 50 mV/mm typ. 17.78 mV/mm typ. 282.16 counts/mm typ.
Update rate 476 µs 400 µs 3200 µs
Baud rate – 57.6 kbits/s
Initial startup time 5 ms 30 ms
Termination
TYCO Super Seal
282087-1
integral connector
ying leads
Cable bend radius – 40 mm [1.6 in] min.
Operating temperature
sensor and
magnet
actuator
-40 °C to 125 °C [-40 °F to 257 °F]
Storage temperature -40 °C to 150 °C [-40 °F to 302 °F]
Air gap 8,5 ±1,0 mm
[0.334 ±0.039 in]
3,0 ±2,5 mm [0.118 ±0.098 in]
Sealing IP67, IP69K
Radiated immunity 100 V/m per ISO 11452-2 –
Conducted immunity
100 mA BCI per ISO
11452-4
–
Shock 50 G half sine wave with 11 ms duration
Vibration 20 G from 10 Hz to 2000 Hz 10 G from 10 Hz to 2000 Hz
Housing material thermoplastic
Approvals CE
Mounting:
screws
recommended torque
¼-20 or M6
6 N m to 10 N m [53.1 in lb to 88.5 in lb]
Material
magnet ac-
tuator only
neodymium iron boron
Strength 13,500 Gauss 10,000 Gauss
Note:
1. Percent linearity is the quotient of the measured output deviation from the best t line at the measured temperature to the full scale
output span.
NOTICE
• Ferrous metal within a 100 mm [3.9 in] radius of the
magnet actuator may affect sensor performance.
• Always use fresh, non-magnetic stainless steel washers
when mounting the sensor.