Owner's Manual

S7350B WebPAD™
19 69-1514-1
USING THE WebPAD™
System Requirements
The S7350B uses a wireless transceiver conforming to the IEEE 802.11b wireless LAN protocol for connecting to the local
network. To connect to an in-home Ethernet network, an in-home PC acting as a DHCP server, or directly to an Internet Service
Provider, the industry offers several types of matching transceivers as network access points or base stations. Standalone access
points, bridges and routers, and PC based solutions are available.The actual matching device depends on the network
configuration. See Appendix A.
To connect to an Ethernet 10BaseT network, you need an 802.11b-based access point or an 802.11b-based wireless router/
gateway to operate with the S7350B. These devices are available from Honeywell (H-Link). See Appendix A for suggestions of
compatible S7350B equipment.
Operation
Button Functions
CAUTION
LCD Screen Damage Hazard.
Touching with non-recommended objects and exposing to direct sunlight/heat can damage screen.
Do not touch with your fingers; oil from your skin can be difficult to remove.
Use only stylus provided.
Avoid screen exposure to direct sunlight or other heat source.
CAUTION
Loss of Product Warranty Hazard.
Removing back cover can void product warranty.
Do not remove or try to remove the back cover; contact Honeywell H-Link for service assistance.
Power On and Off (See Button Functions Section)
1. Turn on power with pull and quick-release of power switch on the left edge of the device. Power LED turns green, indicating
device is ready to use.
2. Turn off power by pulling and holding switch for about four seconds. Power LED and display go off. A beep also sounds.
NOTE: The S7350B is configured to automatically launch the Internet browser to a pre-configured web-site. You may access
the Windows CE desktop at any time by clicking on the Desktop icon. See Figure 15 below.
NOTE: An out-of-the-box S7350B will not have the wireless link configured. As such, the device will ask for wireless configura-
tion information (see Appendix A) when powered on as a new device or if the factory default settings have been restored
(see Registries Save/Restore configuration below). After a set of wireless link information has been provided, the
S7350B will us these settings to automatically launch the Internet browser and access the default URL (web-site).
Button Function Location Description
Power switch:
Sleep mode entry/exit
Full Power Off
Power On
Left side Power switch manual start/stop:
Pull and quick-release for Sleep.
Pull and hold four seconds for Full Power Off.
Pull and quick-release for Power On.
Soft keyboard Lower right front Enable/disable keyboard on screen.
E-mail Lower right front Open/close inbox application.
Desktop or
“*”
Lower right front Minimize/maximize current window; show CE desktop or
go to Web-based portal.
Honeywell H-Link Lower right front Access Honeywell Website.
Scroll key Lower left front Scroll vertically.