User Manual

22 PX940 User Guide
Connect the Printer to an Ethernet Network
Use the Ethernet port to set up your printer as a network printer. The printer is set
to automatically retrieve an IP number from the network (DHCP) when you turn the
printer. You can use the network connection with InterDriver. You can also use it to
send commands directly to the printer through a terminal connection (Telnet), or
through FTP.
1. Turn the printer off.
2. Connect the Ethernet cable to the Ethernet port in the rear of the printer and
connect the other end of the cable to your network.
3. Turn the printer on.
4. If your printer uses a DHCP server to assign IP addresses, the IP address
appears in the lower left corner of the screen.
• For an icon printer, use Honeywell PrintSet 5 to retrieve the printer IP
address.
5. If you are not using a DHCP server to automatically assign IP addresses to
devices in your network, you must set a static IP address and other network
information manually. Continue with the next step.
6. For a non-DHCP network:
• For a full touch printer, from the Main Menu select Settings >
Communications > Ethernet > IPv4 or IPv6 and change the settings as
needed.
• For an icon printer, configure the Ethernet settings through Honeywell
PrintSet 5.
Setting Default
(IPv4) IP Assignment Method DHCP
(IPv4) IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Default Router 0.0.0.0
DHCP Response Broadcast
(IPv6) IP Assignment Method Automatic
(IPv6) IP Address Automatic