User Manual

84 PM45 and PM45c User Guide
Maintenance Alerts
To view these settings:
• From the printer Main Menu, select Settings > System Settings > Maintenance
Alerts.
• From the printer web page, click Configure > System Settings > Maintenance
Alerts.
SSH Determines if the printer can use Secure Socket Handling (SSH). Disable
Telnet Determines if the printer can use Telnet. Disable
XML Determines if the printer can use XML printing. Enable
Time Server Determines if the printer uses the Network Time Protocol (NTP) to
synchronize its time with a network time server. The default Server
Address is ntp0.cornell.edu, and the default Port Number is 123.
Disable
Device
Management
Determines if the printer can use 9300 TCP/IP port to
communicate with HCD.
Disable
Connectivity
Agent
Determines if the printer can communicate with Honeywell Cloud
on port 10000.
Disable
System
Network
Service Setting
Description Default
Maintenance
Alerts Setting
Description Default
Odometer (User
Resettable)
Sets the length of media (in meters) that the printer prints
before the Odometer (User Resettable) alert is sent, if this
alert is configured. Unit of measurement is defined in the Unit
of Measure parameter. Range is 0 to 4294967295.
0
Odometer (Printer) Sets the length of media (in meters) that the printer prints
before the Odometer (Printer) alert is sent. Unit of
measurement is defined in the Unit of Measure parameter.
Range is 0 to 4294967295.
0
Odometer (Printhead) Sets the length of media (in meters) that the printer prints
before the Odometer (Current Printhead) alert is sent, if this
alert is configured. Unit of measurement is defined in the Unit
of Measure parameter. Range is 0 to 4294967295.
0
Replace Printhead Sets the length of media (in meters) that the printer prints
before the Replace Printhead alert is sent, if this alert is
configured. Unit of measurement is defined in the Unit of
Measure parameter. Range is 0 to 4294967295.
0
Clean Printhead Sets the length of media (in meters) that the printer prints
before the Clean Printhead alert is sent, if this alert is
configured. Unit of measurement is defined in the Unit of
Measure parameter. Range is 0 to 4294967295.
0
Faulty Dot Sets the number of faulty dots on the printhead before the
Faulty Dot alert is sent, if this alert is configured. Range is
0 to 4294967295.
0