User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
4 PM45 and PM45c Accessory User Guide
Remove Electronics Cover
To remove the electronics cover,
1. Remove the media cover.
2. Use a T20 Torx screwdriver to remove the two screws that secure the
electronics cover to the inside of the printer base.
3. Use a T20 Torx screwdriver to remove the two screws located on the outside of
the electronics cover.
4. Remove the electronics cover, and put the cover aside on a soft cloth to avoid
scratches.