Install Instructions

ManualsBrandsHoneywell ManualsDamper actuatorsMedium Force Damper Actuator w/ Spring Return for Variable Volume Terminal Units (9 to 13 psi)

MP909E UL LISTED DAMPER ACTUATOR

 Remove mounting screw from damper end of truss link.

Loosen screw between base and truss link. Remove

clevis pin from damper end of actuator pushrod.

 Set actuator in place by hooking actuator mounting

clamp over bottom edge of damper frame.

 Set damper to the normal (closed) position.

 Insert clevis pin in drive ear hole marked P and the

pushrod hole nearest the actuator.

 Connect truss link to damper and tighten both truss link

screws.

 Tighten damper mounting screws.

 Go to PIPING section.

(430)

1-1/8 (30) CLEARANCE

MP909E

1-1/2

(39)

1-1/2

(39)

6-7/8

(175)

5-3/4

(145)

AXLE

ROTATION TO

NORMAL

C8092

Fig 1. External Mounting Dimensions in Inches (Millimeters).

FACEPLATE

MOUNTING

BRACKET

C8209

90°

AXLE

ROTATION TO

NORMAL

MOUNTING HOLES

CRANKARM

CLEVIS PIN LOCATION ON

1-3/8(35)

REF.

3.1-INCH STROKE OPERATORS

Fig. 2. External Mounting Faceplate Positioning.

(FACTORY INSTALLED)

1-5/8 INCH (41 MM) FOR 3.1 INCH STROKE

OPERATORS AND N.C. DAMPERS

C8208

Fig. 3. External Installation.

95-6076