Full Product Manual

LED UTILITY LIGHT

MODEL: MA0201-XXXX

USE AND CARE GUIDE

International Development, LLC.

899 Henrietta Creek Rd. Roanoke, TX 76262 USA

Toll-free: 1-877-723-0723

The Honeywell Trademark is used under license from Honeywell International Inc.

Honeywell International Inc. makes no representations or warranties with respect to this product.

This product is manufactured for International Development, LLC.

PROBLEM

Light will not come on. A. Light switch is turned off.

B. Fuse is blown or circuit breaker

is turned off.

C. Incorrect circuit wiring.

A. Turn light switch on.

B. Replace fuse or turn circuit

breaker on.

C. Verify that fixture is wired properly.

POSSIBLE CAUSE SOLUTION

Lights come on during

the day.

A. Photocell covered.

A. Clean photocell with damp cloth.

TROUBLE SHOOTING

FCC WARNING:

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user authority to operate the equipment.

**********************************************************************************************

NOTES:This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

PAGE 1
TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Light will not come on. A. Light switch is turned off. B. Fuse is blown or circuit breaker is turned off. C. Incorrect circuit wiring. A. Turn light switch on. B. Replace fuse or turn circuit breaker on. C. Verify that fixture is wired properly. Lights come on during the day. A. Photocell covered. A. Clean photocell with damp cloth.
PAGE 2
SAFETY INFORMATION INSTALLATION WARNING: Read all safety precautions and installation instructions carefully before installing or servicing this fixture. Failure to comply with these instructions could result in a potentially fatal electric shock and/or property damage. • To reduce the risk of electrical shock or other personal injury ensure the power is power is turned OFF at the fuse or circuit breaker box before installing or servicing any part of this fixture.