Use And Care Manual

ManualsBrandsHoneywell ManualsAir Purifiers & AccessoriesFilter F Long Life True HEPA Replacement Filter

UNIVERSAL PERMANENT

REPLACEMENT HEPA FILTER

One HEPA filter and one gasket included

Instructions for Use:

Refer to your air purifier’s owners manual for additional

instructions and guidelines.

1. Turn the air purifier off and unplug from the wall outlet.

2. To open, unscrew the locking mechanism, and separate the lid (or

endcap for 17000 Series Models) from the base.

3. Remove the filter assembly (pre-filter and HEPA filter) from the

internal chamber.

4. Remove the pre-filter from the HEPA filter. Discard the HEPA filter.

5. Remove the new Permanent HEPA filter from its package.

6. Refer to the filter fit chart on the reverse side of this instruction

sheet to determine:

a) The number of HEPA filters needed for your air purifier.

b) If a gasket is needed for your filter assembly.

7. If more than 1 HEPA filter is needed with

no gasket required,

carefully stack the filters on top of each other so they evenly align

and fit together (Fig.1).

8. If the HEPA filter(s) requires a gasket(s), stack and evenly align the

filters together with the gasket placed on top of the HEPA filter(s)

(Fig.2).

9. Carefully wrap the pre-filter around the new HEPA filter(s) and

attach using the fasteners provided with the pre-filter. If your pre-

filter is over 3 months old, you should replace with a new pre-filter.

10. Place the filter assembly into the internal chamber. If you are using

a gasket, make sure the gasket is located closest to the lid (or

endcap) of the air purifier.

11. Replace the lid (or endcap) and base, and tighten the locking

mechanism. Turn the air purifier to an operable position.

12. If your air purifier unit has the Intelli-Check

™

filter monitor feature,

(all 50000, 17000 and 18150 Series models, except the 50100),

the system will need to be reset every time the pre-filter is

changed or HEPA filter is cleaned.

To reset the Intelli-Check

™

feature:

• Turn the unit on to the High speed setting.

• Press and hold the appropriate filter indicator button (HEPA or

pre-filter) for approximately 10 seconds until the light turns off.

• Release the button.

• The HEPA or Pre-filter LED light should now be reset.

13. Your air purifier is now ready for operation.

Fig. 1

Fig. 2

Model HRF-14

Gasket

Filter

HRF-14_Sheet_R3.qxd 8/12/05 4:09 PM Page 1

Summary of content (2 pages)

PAGE 1
HRF-14_Sheet_R3.qxd 8/12/05 4:09 PM Page 1 UNIVERSAL PERMANENT REPLACEMENT HEPA FILTER Model HRF-14 One HEPA filter and one gasket included Instructions for Use: Refer to your air purifier’s owners manual for additional instructions and guidelines. 1. Turn the air purifier off and unplug from the wall outlet. 2. To open, unscrew the locking mechanism, and separate the lid (or endcap for 17000 Series Models) from the base. 3.
PAGE 2
HRF-14_Sheet_R3.qxd 8/12/05 4:09 PM Page 2 UNIVERSAL PERMANENT REPLACEMENT HEPA FILTER FIT CHART Use the filter fit chart below to determine how many filters and gaskets you will need to complete the filter assembly for your air purifier model. To select the number of Universal Permanent Replacement HEPA filters needed, find the first four digits of your Honeywell enviracaire® model number in the table below, then read across to determine the quantity of filters required.