Portable Evaporative Air Cooler User Manual Read and save these instructions before use Scan here: www.honeywellaircoolers.com www.jmatek.com E-mail: usinfo@jmatek.
PARTS DESCRIPTION (1) (10) (2) (3) (11) (12) (6) (15) (7) (13) (16) (14) (4) (8) (5) (9) (17) 7) Power Cord Wrap 8) Water Tank 9) Power Cord & Plug 10) Plastic Net Filter 11) Rear Grill Screw 12) Honeycomb Cooling Media 1) Control Panel 2) Handle 3) Louvers 4) Water Level Indicator 5) Casters 6) Ice Compartment Lid 13) Rear Grill 14) Water Regulator 15) Water Fill Door 16) Water Inlet Valve 17) Drain Plug WARNING -- READ AND SAVE THE AIR COOLER SAFETY & MAINTENANCE GUIDE AND USER MANUAL BEFORE U
USE & OPERATION (CONTINUED) FUNCTION BUTTONS (CONTINUED) Pressing the MODE button until both “S” and “C” are illuminated will activate both Swing (Vertical Louvers) and Cool modes simultaneously. Note: When the “C” mode is not selected, the unit functions in a fan only mode, without evaporative cooling. SPEED Press the SPEED button repeatedly to change the speed between High - Medium - Low.
USE & OPERATION (CONTINUED) REMOTE CONTROL (CONTINUED) Note: t The remote control requires AAA (2 x 1.5V) batteries for replacement. t Open the battery compartment at the back of the remote control and insert the batteries inside. Care must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside the battery compartment. t Always point the remote control signal transmitter towards the unit when operating. Make sure that the signal path is not obstructed.
USE & OPERATION (CONTINUED) FILLING WITH WATER (CONTINUED) Manual Water Tank Refill: Open the Water Fill Door located on the side of the unit. The Water Level Indicator is located at the front of the unit. Refill the water tank when water level is low. Do not fill water above the "Max." water level mark to avoid water droplets collecting on the louvers. Check the water level in the tank before running the COOL function. Make sure that the water in the tank is above the minimum water level mark.
USE & OPERATION (CONTINUED) CLEANING & DRAINING THE WATER TANK If the cooler will not be used for a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide. WARNING: Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket. t Move the unit to a location where the water can be drained. Remove the cap from the Drain plug located at the bottom of the unit. Allow the tank to empty.
TECHNICAL SPECIFICATIONS Model CO70PE Voltage 110 - 120 V Frequency 60 Hz Ampere 2.4 A Wattage 280 W Cooling Media Honeycomb Product Dimension 706 (W) x 426 (D) x 1008 (H) mm 27.8 (W) x 16.8 (D) x 39.7 (H) in Net Weight 18.5 kg / 40.8 lbs ELECTRICAL WIRING DIAGRAM For USA Outdoor Models Only. This appliance is equipped with a GFCI plug. Press the TEST button and then the RESET button once every month to ensure proper operation.
JMATEK North America LLC Mahwah, New Jersey 07495 USA Phone: 1-800-474-2147 Email: usinfo@jmatek.com Web: www.jmatek.com © 2016 JMATEK Limited. All rights reserved. The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to these products. This product is manufactured by Airtek Int'l Corp. Ltd. (subsidiary of JMATEK Ltd.