Portable Evaporative Air Cooler for Indoor Use OWNER’S MANUAL Read and save these instructions before use Model: CL25AE Power rating: 230 Watts Voltage rating: 120 Volt AC, 60Hz For product inquiries or support, visit www.honeywellaircoolers.com Customer Support : 1-800-474-2147 Made in P.R.C.
QUICK START GUIDE 1 Fill with water and plug into a standard power outlet. Note: Please make sure the household power voltage matches the product specifications. 2 3 Place near an open door or window. Note : Evaporative air cooler requires cross ventilation. Turn ON and enjoy the cooling breeze. Note: Start with LOW speed and gradually increase to higher speed for optimum cooling performance.
INDEX Read all instructions carefully before setting up and operating the cooler, and please keep this instruction manual for future reference. This manual is designed to provide you with important information needed to setup, operate, maintain, and troubleshoot your cooler. Failure to follow these instructions may damage and/or impair its operation and void the warranty. SECTION 1. 2. 3. 4. 5. PAGE THANK YOU .................................................................. .............................
THANK YOU Congratulations on your purchase of this versatile Honeywell Evaporative Air Cooler. For optimum cooling from your cooler, fill the water tank to maximum level and load ice inside the ice compartment before you turn on your air cooler. Cooler Location (Important - Please Read!) Place the cooler in front of an open door or window. Ensure that there is adequate cross ventilation in the room by leaving a door or window open opposite the cooler.
USER TIPS Energy Efficient, No Compressor Honeywell Evaporative Air Coolers are built to maximize energy efficiency and keep costs low. Warm air is drawn into the cooler through a dust and odor-reducing carbon filter and enters the Honeycomb Cooling Media. Water pumped from the tank pours over the honeycomb media. As the warm air passes through the media, the water absorbs the heat, naturally cooling and humidifying the air. A fan propels the cooled air out into the room.
USER TIPS The recommended maximum relative humidity level is 60% or less, which allows a noticeable temperature decrease. The temperature decrease will be greater in drier climates because higher evaporation occurs when the humidity is low. The evaporative air cooler should not be used in enclosed spaces. It must be kept level and there must be water in the water tank. The room should have doors and windows opened to allow free air flow.
SAFETY READ AND SAVE THESE INSTRUCTIONS: When using electrical appliances, basic safety precautions should always be followed: • Your cooler runs on 120 Volt AC, 60 Hz current. Check the household voltage to ensure it matches the appliance's rate specification. • Before operating the product remove it from its packaging and check that it is in good condition. • DO NOT operate any product with a damaged cord or plug. • DO NOT run power cord under carpeting, or cover it with rugs or runners.
SAFETY • DO NOT attempt to repair or adjust any electrical or mechanical functions of the cooler, as this may void the warranty. • DO NOT cover the air inlet or outlet on the appliance as this may cause motor damage. • DO NOT insert or allow objects to enter any ventilation or exhaust opening as this may damage the product and could cause an electrical shock or fire. • DO NOT operate with the Honeycomb Media removed as this will overload and damage the motor.
PARTS DESCRIPTION 7 11 12 1 17 4 3 2 8 16 9 10 15 13 12 5 1 Control Panel 2 Side Handle 3 Horizontal Louvers (Manual Adjustment) 4 Left Side Panel 5 Power Cord & Plug 6 Casters 7 Ice Compartment Lid 8 Vertical Louvers (Automatic Movement with SWING) 14 6 9 Front Panel 10 Water Level Indicator 11 Remote Control 12 Water Tank 13 Water Fill Door 14 Drain Plug 15 Right Side Panel 16 Rear Grill Removal Screws 17 Carbon Filter & Honeycomb cooling media ACCESSORIES: Remote Control ( Batteries not in
USE & OPERATION Control Panel Slee p Lo Med r Hi 0.
USE & OPERATION Function Buttons Power Press the POWER button to turn the unit on. The cooler will start automatically at medium speed. After a few seconds the speed will switch to low. To turn the unit off, press the button again. POWER Speed Press the 'SPEED' button repeatedly and the speed will change. The indicator light will show the selected speed. High (Hi), Medium (Med), Low (Lo) & Sleep.
USE & OPERATION Swing Press the ''SWING '' button. The indicator light will come on and the louvers will begin to move from right to left automatically. Manually adjust the horizontal louvers to change vertical airflow. SWING Low Water Alarm (Will activate in COOL Only mode) The unit is equipped with a low water sensor. When water in the tank is below the minimum level, you will hear 10 beeps and the TANK EMPTY LED indicator will flash continuously.
USE & OPERATION Remote Control Power Speed Mode Swing Timer : On/ Off : Low / Medium / High / Sleep : Controls cooling or fan option : Controls the motion of the vertical louvers : Controls timer function for automatic shut off POWER SPEED SWING MODE TIMER Remote Control (Batteries not included) NOTE • Open the battery compartment at the back of the remote control and insert two new • • • • • • • • AAA dry cell batteries.
USE & OPERATION Room Cooling And Humidifying When the Water Regulator is set to ''MIN'', the water pump distributes minimal amount of water to the Honeycomb Media. This results in less water evaporation and reduces cooling effect. When the Water Regulator is set to ''MAX'', the water pump distributes the maximum amount of water to the Honeycomb Media. This results in maximum water evaporation and the cooling performance improves.
USE & OPERATION CAUTION Unplug from power when refilling. Filling With Water Unplug the air cooler from power supply. Check water level indicator located on the front of the unit to determine the level of water inside the water tank. The water tank of this cooler holds up to 6.6 gallons of water. Be sure water in the tank is always above the minimum water level mark.
CLEANING & MAINTENANCE Important • The cooler is supplied with Honeycomb Cooling Media. • The cleaning frequency for the Honeycomb Media depends on local air and water conditions. In areas where the mineral content of water is high, mineral deposits may build up on the Honeycomb Cooling Media and restrict air flow. Draining the water reservoir and refilling with fresh water at least once a week will help reduce mineral deposits.
CLEANING & MAINTENANCE Draning and Cleaning The Water Tank Turn the power “off” and disconnect the air cooler from the power supply. Move the unit to a location where it can be drained. Remove the drain plug and allow the tank to empty(refer page 7., #14). Refill the water tank up to the maximum level with clean water and drain it completely. • Fill water tank and rinse at least 2-3 times before use. Water Drain Plug • After cleaning ensure that the drain plug is back in place.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION No discharge of air Cord is not plugged in. Make sure power cord is plugged in and the supply switch is on. Power is not on. Turn the unit ON by pressing button on the control panel. Pump is not turned ON. On Control Panel, turn COOL FUNCTION to “ON”. Low or no water in tank, when COOL is selected. Refill water tank. Damaged Pump or Calcium deposits on blower. Contact service center. When the Cooler is new.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE SOLUTION The unit does not respond to remote control Remote control batteries. Check batteries. Replace if needed. Try to operate using the control panel. Damaged PCB. Try with remote control. If the unit responds, PCB board fasteners may be loose. Contact service center. If neither remote control nor control panel works, PCB board may be damaged. Contact service center.
TECHNICAL SPECIFICATIONS MODEL NO. Voltage Frequency Ampere Wattage Water Tank Capacity Cooling Media Product Dimension (Inches) Net Weight 18 CL25AE 120 V 60 Hz 2.1A 230 Watts 6.6 Gallons Honeycomb 18.9 (W) x 14.6 (D) x 33.4 (H) 25.
ELECTRICAL WIRING DIAGRAM 120V 60Hz 19
SERVICE AND WARRANTY 1-YEAR LIMITED WARRANTY Read all the instructions before attempting to use this product. This 1 year limited warranty applies to repair or replacement product found to be defective in material or workmanship. A. This warranty does not apply to any damage resulting from commercial, abusive, unreasonable use or supplemental damage. Defects that are the result of normal wear and tear will not be considered manufacturing defects under this warranty.
SERVICE AND WARRANTY D. Please read the Instruction Manual carefully before setting up or using this product. If you believe this product to be suffering from a manufacturing fault, or if you have inquiries about this product, please contact our Customer Support: CUSTOMER SUPPORT JMA North America LLC Ramsey, New Jersey, 07446. Phone : 1-800-474-2147 Email : info@jmana.us When contacting our Customer Support, please have the information below along with the proof of purchase.
Distributor: JMA North America LLC Ramsey New Jersey 07446 Customer Support: 1-800-474-2147 E-mail: info@jmana.us www.honeywellaircoolers.com November 2012; CL25AE_IM_Eng_HW_9 © 2012 AirTek International Corporation Ltd. All rights reserved. The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to this product. This product is manufactured by Airtek Int’l Corp.
