Portable Evaporative Air Coolers Safety & Maintenance Guide User tips and safety instructions www.jmatek.com Email: usinfo@jmatek.
THANK YOU Congratulations on your purchase of this versatile Honeywell Evaporative Air Cooler. The Safety & Maintenance Guide and the separate User Manual are intended to provide you with important information needed to set up, operate, maintain and troubleshoot this product. USER TIPS What is Evaporative Cooling? Honeywell Evaporative Air Coolers are built to maximize energy efficiency and keep energy costs low. Warm air is drawn into the cooler and enters the Honeycomb Cooling Media.
COOLER LOCATION (CONTINUED) IMPORTANT: The evaporative air cooler is not an air conditioner as it does not use a compressor or refrigerant gas. It should not be expected to cool as efficiently as a refrigerated air conditioner. Outdoors (for outdoor models only) t Use only on GFCI Protected outlets/ sockets (for USA only). Press the TEST button (then RESET button) every month to ensure proper operation. t Power cords must be secured to avoid tripping.
SAFETY RULES (CONTINUED) t t t t t t t t t t t t t When using the COOL setting, make sure the water tank is at Max Indicator Level. Operating the unit on the COOL setting with an empty tank may result in damage to the water pump. DO NOT attempt to repair or adjust any electrical or mechanical functions of the Air Cooler, as this may void the warranty. DO NOT cover the cooler’s air inlet or outlet, as this may damage the motor.
STORAGE AND MAINTENANCE GUIDELINES Read the detailed CLEANING & DRAINING THE WATER TANK instructions for your Air Cooler, located in the separate User Manual. Below is a general guideline for maintenance and storage of your Air Cooler. WARNING: Always switch OFF the Air Cooler and unplug it from the electrical source before cleaning or maintenance. Cleaning At least once a week, drain the water tank completely and refill with fresh water.
TROUBLESHOOTING GUIDE Customer Service Center: See the last page of the User Manual to find the contact details for the Customer Service Center for your area. PROBLEM No discharge of air. Not Cooling / Unit is making noise. Excessive humidity in the room. Odors. POSSIBLE CAUSE SOLUTION Cord is not plugged in. Make sure power cord is plugged in and the switch is ON. Power is not ON. Turn the unit ON by pressing the power button on the control panel or remote control. Pump is not turned ON.
JMATEK North America LLC Mahwah, New Jersey 07495 USA Phone: 1-800-474-2147 Email: usinfo@jmatek.com Web: www.jmatek.com © 2016 JMATEK Limited. All rights reserved. The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to these products. This product is manufactured by Airtek Int'l Corp. Ltd. (subsidiary of JMATEK Ltd.
