Electric Foldable Bicycle 1
WELCOME Thank you for purchasing a Honeywell electric bike! We wish you many happy rides with your new ebike! Please read and understand all sections of this entire manual before operating the bike for the first time. This manual contains important safety, performance and service information. Failure to follow the instructions and warnings may lead to serious injury or death.
TABLE OF CONTENTS General info ……………………………………………………………………………………………………………………………………………… 4 Battery ……………………………………………………………………………………………………………………………………………………….. 6 Assembly instructions …………………………………………………………………………………………………………………………… 9 Operation ………………………………………………………………………………………………………………………………………………….. 12 Maintenance and care ………………………………………………………………………………………………………………………….. 17 Warnings and safety ……………………………………………………………………………………………………………………….........
GENERAL INFO Speed Limit Your Honeywell electric bike can assist you up to 20MPH (32 km/h), which is the legal limit in most areas in U.S. Honeywell bikes are considered Class 2 electric bikes. Riding Range Your electric bike can travel up to 40 miles with pedal assist on a single full charge of the battery. However, the range may vary depending on elevation, speed, assistance level, rider weight, headwind and ambient temperature, tire type and pressure, road condition etc.
GENERAL INFO (CONTINUED) Transportation and Storage • When transporting the bike, make sure the power is off. • If transporting on a vehicle, be aware of the maximum load capacity of the vehicle’s roof, towing hook and/or the bicycle carrier and make sure the battery is removed and stored elsewhere in the vehicle. • Always know and obey the local laws regarding transportation of an electric bicycle. Check with your airline or local carrier before transporting your bike.
BATTERY General Info • Your electric bikes uses Lithium-Ion battery which can be charged on or off the bike. • Make sure to fully charge the battery for about 8 hours before the first use. • A full charge normally takes about 4-5 hours when the battery is not completely empty. • When battery is completely empty (0% charge), a normal charge of 4-5 hours might not be sufficient. It is necessary to proceed with an 8 hours charge. Charging Procedure • Make sure that the bike is turned off while charging.
BATTERY (CONTINUED) Battery Removal/ Installation • Ensure the bike is turned off and folded while removing or installing the battery. • Insert the key in the lock and turn it to unlock the battery box. Carefully remove/insert the battery from/into the bike. • Ensure the battery has been properly secured to the bike. Do not ride the bike if the battery rattles or moves. • Do not touch the “+” and “-” terminal contacts on the bottom of the battery when the battery is removed from the bike.
BATTERY (CONTINUED) Battery Safety and Care • Make sure to turn off the bike while charging. • Check the charger, charger cables, plug and battery for damage before each charge, and ensure these components are dry to avoid any short circuit. • Only use the originally included battery and charge, please contact us if you need any replacement. • Do not cover up the charger when plugged in or charging. • Do not open the battery housing as it will void warranty.
UNFOLD INSTRUCTIONS Step 1: Unfold the handlebar Step 2: Unfold the bike frame and pedals Unfold the handlebar stem so that it is in the upright position, then lock the stem into place with the locking lever. Unfold the bike frame clockwise. Locate the twisting lock handle on the underside of the bike frame and turn the handle until it is tight. Finally, unfold the pedals.
FOLD INSTRUCTIONS Step 1: Fold the handlebar Step 2: Fold the bike frame Unlock the stem lever and fold the handlebar stem. Locate and loosen the twisting lock handle on the underside of the bike frame. Fold the bike frame counterclockwise.
ADJUSTMENT INSTRUCTIONS Adjust the handlebar Unlock the stem lever and adjust the handlebar to your preferred position, then relock the lever after adjustment. Adjust the seat height Your seat height should be adjusted properly to ensure you get the most comfortable ride possible. The seat height can be adjusted by loosening the lever on the seat tube clamp. Make sure to retighten after adjustment.
OPERATION LCD Display Operation The table and image below show the various features and information displayed on the LCD display. Location Information 1. POWER button 2. PLUS button 3. MINUS button 4. Distance (MPH or KM): (Current distance traveled TRIP/ Total distance traveled ODO /Real-time battery voltage TIVOL) 5. Real-time Speed (MPH or KM/H) 6. Pedal Assist Level (PAS): (0 – 5) Mode; 0 = No assistance 7.
OPERATION (CONTINUED) Please read and understand all sections of this entire manual before operating the bike for the first time. Ensure the bike has been properly assembled and the pre-ride safety check has been performed. Turning on/off the e-bike • Your electric bike is operated using the display on the handlebar. Press and hold the ‘POWER’ button to turn-on or turn-off the display and the motor power supply of the bike.
OPERATION (CONTINUED) Throttle • Your electric bike is equipped with a thumb throttle, which is mounted near the rider’s right thumb. No pedal is needed once the bike is moving on the throttle power. • Simply push the throttle using your thumb and the throttle can propel you at speeds up to 20 mph (32km/h). • The throttle can only be engaged within pedal assist levels 1 though 5. Your bike will accelerate to the top speed of the selected pedal assist level.
OPERATION (CONTINUED) Display Mode Press the ‘POWER’ button to cycle through the different modes of the display.
OPERATION (CONTINUED) Error Codes Your Honeywell electric bike is equipped with an error detection system integrated into the display. In the rare event of an electrical issue with the bike, an error code may appear on your display. Please note the error code and contact Honeywell Bikes Support at (800)-768-0792 immediately.
MAINTENANCE AND CARE General Bike Care • Just like standard bikes, regularly clean and check your electric bikes components. Always remove the battery and turn off the bike before performing any inspection or service. • We recommend lubricating the bike chain every two months. • It is recommended to have your bike inspected and adjusted every 3 months by a professional bicycle technician. • Honeywell electric bikes and their components are water resistant. Riding in rain or snow should not cause any damage.
MAINTENANCE AND CARE (CONTINUED) Pre-ride Safety Check It is recommended to perform a safety check of your electric bike before each ride. • Make sure tires are properly inflated. Use a reliable tire gauge to check the tire pressure, if the pressure is too low, inflate your tires until you reached the recommended pressure as shown on the tire sidewall. Inspect the outer surface of the tires.
WARNINGS AND SAFETY This manual contains important safety, performance and service information. Failure to follow the instructions and warnings may lead to serious injury or death. • All users must read and understand this manual carefully before riding on the new electric bicycle. Always keep this manual for future reference. • Check your bicycle for proper fit and installation, normal operation, loose parts and defects before riding. If you find any problem, please contact us before riding.
WARNINGS AND SAFETY (CONTINUED) This manual contains important safety, performance and service information. Failure to follow the instructions and warnings may lead to serious injury or death. • Take extra care while riding in wet condition such as snow and rain. • Some bike accessories may present a choking hazard to small children. Always keep these accessories away from children. • Check the user manual for maximum riding weight and loading capacity of your electric bicycle.
WARRANTY All Honeywell electric bikes and their components carry 1-year manufacturer warranty with the original registered owner. Please carefully read our warranty terms below. If you believe your electric bike has a warranty issue, please contact us directly.
WARRANTY (CONTINUED) Warranty Exclusions • Normal wear and tear • Damage or failure resulting from failure to follow instructions in the owner’s manual • Damage or failure from abuse, neglect, misuse, improper repairs or accident • Damage or failure from modification of any of the bike systems • Damage or failure of any part of the electrical system resulting from improper storage or charging of the battery • Damage or failure from the replacement of any of original components or installation of aftermarket
WE ARE HERE TO HELP If you have any questions or need service, please access our Help Center to submit a request, and/or contact us by email or a phone call for a solution. Help Center: : https://honeywellbikes.zendesk.com Email: support@honeywellbikes.
Raze Outdoors LLC. Sturtevant, WI 53177 Phone: 800-768-0792 Email: support@honeywellbikes.com Web: www.honeywelbikes.com Made in China © 2021 Raze Outdoors LLC. All rights reserved. The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to this product. This product is manufactured by Raze Outdoors LLC.
