User's Guide

Wireless Mesh Configuration
Setting up wireless networks
92 OneWireless Multinode User's Guide R110
6/08
Screen / Option Mesh node 1 Mesh node 2, 3, …n
nodes 2, 3, …n node 1
Wireless Mesh - MAC Address Filtering screen
Filtering: Enable/Disable Enable/Disable
Filter Type: Deny All/Allow All Deny All/Allow All
MAC Address: Add MAC address of Mesh
nodes
Add MAC address of Mesh
nodes
Table 16 Point-to-Multipoint network settings for Manual Mesh
Screen / Option Mesh node 1 Mesh nodes 2, 3, 4, …n
Wireless Mesh - General screen
Mesh mode: Manual Mesh selected Manual Mesh selected
Signal Strength LED
MAC:
Not Assigned (select from
drop-down list)
Not Assigned (select from
drop-down list)
Spanning Tree Protocol
(STP) 802.1d:
Enable (or Disable if no mesh
loop possible)
Enable (or Disable if no mesh
loop possible)
Wireless Mesh - Radio screen
Wireless Mode: 802.11a 802.11a
Tx Rate: AUTO AUTO
Channel No.: Must be the same as Mesh
nodes 2, 3, …n
Must be the same as Mesh
node 1
Tx Power Mode: Auto Auto
Propagation Distance: < 5 Miles < 5 Miles
RTS Threshold: 2346 2346
Beacon Interval: 100 100
Wireless Mesh - Encryption screen
Mesh encryption options Must be the same as Mesh
nodes 2, 3, …n
Must be the same as Mesh
node 1