Service Manual

Part No: 4417762 Revision 12 Service Manual 187
990 SmartRadar FlexLine
7.5.10 Firmware Upgrade for R120
You can upgrade the radio firmware through OneWireless Wireless
Builder.
For more details see the Wireless Builder manual in the chapter
“Upgrading Firmware in commissioned device”.
NOTE: Only the radio firmware can be upgraded through
Wireless Builder. Firmware upgrade of the HCI-1WL
board and the other FlexConn boards is performed
through the normal FlexConn upgrade procedures.
7.5.11 Firmware Upgrade for R230
7.5.11.1 Upgrading the SmartRadar FlexLine device firmware using Wireless Device
Manager
The devices at the farthest hop level must be upgraded first.
Sensor firmware
To upgrade the SmartRadar FlexLine sensor firmware, refer to section
“Upgrading CAN-1WL FlexConn board of SmartRadar FlexLine gauge”
in the SmartRadar FlexLine Migration User’s Guide.
Radio firmware
1. On the Selection Panel of the OneWireless user interface, select the
field device.
You can select multiple devices of the same type using the Selection
Panel or the map view. Use SHIFT+click to select multiple items in a
successive list. Use CTRL+click to select multiple items not in
succession.
2. On the ribbon bar, in the Upgrade group, click Radio.