Technical Specifications

Rev 4/2014



PLUMBING REQUIRMENTS

 Unit is equipped with flexible, metal braided ½ inch water supply

hose with ½ female threaded connectors

 Need to install hot and cold shutoffs with ½ male threaded

nipples (not included)

 It is advised to have tub onsite before preparing drain location.

 Note:

The flexible drain hose that is included with this unit is for

installation into a floor drain only. Substituting the existing drain show for

a different one will not void the warranty as long as there is no damage or

evidence of misuse.

ELECTRICAL INFORMATION FOR HEATED AIR

PUMP (HY 1204)

 Air jet motor with heater 110 volt

 Dedicated 12-2 wire with 110 volt, 15-20 amp GFCI breaker

ELECTRICAL INFORMATION FOR SYLLENT BRAND WATER PUMP

(HY 1104)

 3/4 HP water pump with internal heater

 12-2 wire with 110 volt, 20 amp GFCI breaker

 Energy efficient pump

HY1X04

FEATURES

 Outward Swinging Waterproof 24 3/8” walk-in door

 Comfortable deep molded seat

 Left/Right Models Available

 Easy installation (4-6 hours)

 Free Standing or Built in

 Matte finish

 Safety grab bar & Tub Fill

 Water Temperature Controls

 Accessory rack

 Hand held shower

 Drain access panel

 Factory tested

 Extension Panel (optional extra)

Available in three versions:

HY1104 – 10 whirlpool jets with built-in heater

HY1204 – 24 heated air jets

HY1304 – simple soaking tub

Optional Surround set available (Mod. FP04)

Right Hand Drain Air Tub shown

PAGE 1
HY1X04 FEATURES             Right Hand Drain Air Tub shown  Outward Swinging Waterproof 24 3/8” walk-in door Comfortable deep molded seat Left/Right Models Available Easy installation (4-6 hours) Free Standing or Built in Matte finish Safety grab bar & Tub Fill Water Temperature Controls Accessory rack Hand held shower Drain access panel Factory tested Extension Panel (optional extra) Available in three versions: HY1104 – 10 whirlpool jets with built-in heater HY1204 – 24 heated air jets H
PAGE 2
GENERAL INFORMATION  Note: It is advised to have the tub onsite before preparing drain location. Unit must be leveled in its permanent position and all feet must be on the ground to fully support the tub Manufacturer reserves the right to change specs or features at anytime. Please check to confirm details.