Installation Guide

ManualsBrandsHOMESTYLES ManualsBathOrleans 25 in. W x 64 in. H x 8-1/2 in. D Metal Over the Toilet Storage Space Saver in Gray

Hardware List

Part List

IMPORTANT NOTE

Carefully remove all the parts from the carton and put

them individually on a soft cloth to prevent scratches

or other damages occuring to the parts.

We have taken great care in the design of this

product and request that you carefully and strictly

follow our assembly instructions to ensure a

completed product as it was designed.

Shelf

3 pcs.

Stretcher

1 pc.

Top

1 pc.

Side Frame

1 pc.

Side Frame

1 pc.

Tools required for assembly : Tools recommended for assembly :Phillips screwdriver Level

Home Styles Consumer Assistance: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319

88 5760 106

The Orleans Space Saver

Support

2 pcs.

Hex Wrench

1 pc.

Head Cap Bolt

(short)

8 pcs. (+1 extra)

Small

Hex Wrench

1 pc.

Spring Washer

16 pcs. (+1 extra)

Flat Washer

16 pcs. (+1 extra)

Head Cap Bolt

16 pcs. (+1 extra)

Cap Nut

1 pc. (+1 extra)

Head Cap Bolt

(for stretcher)

2 pcs. (+1 extra)

Head Cap Bolt

(for support)

1 pc. (+1 extra)

Summary of content (4 pages)

PAGE 1
88 5760 106 The Orleans Space Saver IMPORTANT NOTE Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damages occuring to the parts. We have taken great care in the design of this product and request that you carefully and strictly follow our assembly instructions to ensure a completed product as it was designed. Part List A. Top 1 pc. B. Side Frame 1 pc. C. Side Frame 1 pc. D. Shelf 3 pcs. E. Support 2 pcs. F. Stretcher 1 pc.
PAGE 2
Assembly Instructions 2/3 IMPORTANT * Do not tighten up all the screws until each part is properly assembled. * You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future. * After assembly, item must be level to work properly. Use the included adjustable levelers to level. STEP 1 Place Top (A) upside down on a soft cloth. Attach Side Frame (B), (C) onto Top (A) with Head Cap Bolts (short).
PAGE 3
Assembly Instructions 3/3 STEP 3 Turn the unit upright and place it at desired location in room. Attach Stretcher (F) to unit with Head Cap Bolts (for stretcher). F Head Cap Bolt (for stretcher) STEP 4 To level the unit, adjust the adjustable levelers on the bottom of unit (See Figure 4). Note: Unit must be level to work properly.
PAGE 4
Attention ! For safety reasons, we recommended you strictly follow these additional instructions to prevent the unit from tipping over. HARDWARE LIST Anchor 1 pc.(+1 extra) Plastic Belt 1 pc.(+1 extra) Bracket 1 pc.(+1 extra) Wall Screw 1 pcs. (+1 extra) Assembly Instructions Wall Bracket Wall Screw Place the unit at desired location in room. Drill a ¼” hole in wall at the appropriate location. Insert the Anchor into the wall hole and attach the Bracket using the wall screw.