Chair Side Table Assembly Instructions Product Dimensions: 22.5” L x 11”D x 23.75”H Please take a moment to read through the entire instruction booklet before assembly to familiarize yourself with this product. Once you feel ready to start, follow the instructions step by step and this should make this process as easy as we could make it for you.
WARNING ! CAUTION ADULT ASSEMBLY REQUIRED CHOKING HAZARD • This product includes small parts, sharp points and sharp edges in its unassembled state. Keep unassembled parts away from children under 3 years of age, and animals. SAFETY WARNINGS • Follow the information on the warnings appearing on table and on the carton. Do not remove warning label from table. • Do not allow children under 3 years of age to use the table. • Do not use substitute parts.
ASSEMBLY AT A GLANCE Please take a moment to read through the whole instruction booklet before assembly to familiarize yourself withthisproduct . Once you feel ready to start, follow the instructions step by step and thisshould mak e thisprocess as easy as we could make it for you. 1 2 4 7 5 3 6 This drawing is to give you an overall idea only of how this assembly will go together and does not replace the assembly instructions.
COMPONENT PARTS Please check that you have all the parts listed below 1 1. Table top ×1 2. Tablecase left ×1 3. Tablecase right ×1 2 4 4.Table shelf support ×1 5.Table shelf support ×1 6.Bottom shelf ×1 7.
ASSEMBLY INSTRUCTIONS 1 Select 1,4,5,B×3,D×8.Insert B×3 into 1, insert D×4 into both sides of 4.Repeat D×4 for 5. D B D B 4 1 D D 5 D D D 2 Select 2,4,5,6,C×2,E×2,F×2,H×1. Install 6 into the right side of the 2. Install 4,5 into the 2, and insert F×1 into the right middle hole of the E 4.Repeat F×1 for 5. Insert E×2 into the top middle hole of the 2 with the Allen Wrench.Insert C×2 into the right of the 6.
ASSEMBLY INSTRUCTIONS 3 Select 3,7,E×2,F×2,H×1.Insert the 7 between the 4 and the 5.Insert E×2 into the top hole of the 3 with the Allen Wrench and into the 7 and 6. Insert F×1 into the end of 5.Repeat F×1 for 4. 2 6 4 7 F 5 E F 3 E H 4 Select C x2. Insert C x2 into bottom holes of 3 and into 6. Tighten with C. Repeat for C x2 for 2 and into 6.
ASSEMBLY INSTRUCTIONS 5 1 Install the 1 on the 2,3,4,5 and secure it with A×3. 2 A 4 5 3 6 The 1 can be lifted to serve as a desktop. Insert G×2 into the top of the both sides of 3 and into 4,5 to serve.Repeat G×2 H for 2 and 4,5.
Page 8 of 8