Nailhead Headboard Assembly Instructions Product Dimensions: 62”W×3”D×48”H Please take a moment to read through the entire instruction booklet before assembly to familiarize yourself with this product. Once you feel ready to start, follow the instructions step by step and this should make this process as easy as we could make it for you. .
WARNING ! CAUTION ADULT ASSEMBLY REQUIRED CHOKING HAZARD • This product includes small parts, sharp points and sharp edges in its unassembled state. Keep unassembled parts away from children under 3 years of age, and animals. SAFETY WARNINGS • Follow the information on the warnings appearing on headboard and on the carton. Do not remove warning label from headboard. • Do not allow children under 3 years of age to use the headboard . • Do not use substitute parts.
ASSEMBLY AT A GLANCE Please take a moment to read through the whole instruction booklet before assembly to familiarize yourself with this product. Once you feel ready to start, follow the instructions step by step and this should make this process as easy as we could make it for you. 3 3 1 2 2 This drawing is to give you an overall idea only of how this assembly will go together and does not replace the assembly instructions.
COMPONENT PARTS Please check that you have all the parts listed below 3 1. Headboard ×1 2. Leg ×2 3.
ASSEMBLY INSTRUCTIONS 1 Remove #2 Legs (x2) bolted to back of 1 1 1 2 2 2 Attach #2 Leg (x2) to #1 with A bolt (x4).
ASSEMBLY INSTRUCTIONS 3 (SKIP THIS STEP IF MOUNTING HEADBOARD TO WALL) If attaching to bedframe, Insert A bolt into #2 leg and attach to your bedframe mount on your bedrails (not included) with B washer and C Nut.
ASSEMBLY INSTRUCTIONS 1 D Measure using paper wall mount template (included in the back of instructions) to mark your holes and ensure your mounts are even and level. Drill (tool required not included) small pilot holes and install Dx4 into the pilot holes with hammer (tool required - not included). Insert E (x2) into each hole of 3 and tighten with screwdriver into D wall anchors. Repeat for other E. . D D D D D 3 E 2 Hang 1×1 on the wall.
ASSEMBLY INSTRUCTIONS CONGRATULATIONS, YOUR NAILHEAD HEADBOARD IS COMPLETE! Page 8 of 9
ASSEMBLY INSTRUCTIONS Back of Assembly Instructions Folded Paper Template 400mm 400mm 400mm 400mm Make sure your template is level before marking your holes. Use masking tape to temporarily secure template on wall when ensuring paper is completely flat and even. Use a level to adjust position. Then press pencil through center of marked holes on template to mark pilot hole target behind paper. Remove paper template when satisfied with placementand proceed to Wall Mount Instruction step 1.
