Use and Care Manual

ManualsBrandsHomelite ManualsKitchen1800-PSI 12 in. EZ Clean Surface Cleaner

WARNING:

To reduce the risk of injury, user must read and understand

the operator’s manual for their pressure washer before us-

ing this accessory. To reduce the risk of injury or property

damage, spray the pressure stream in a safe direction

to ensure proper connection of all accessories before

starting any cleaning project. Fits most pressure wash-

ers. Ensure compatibility and proper fit before using this

accessory. Always wear eye protection with side shields

marked to comply with ANSI Z87.1. Risk of fluid injec-

tions; do not point at people, pets, electrical devices or

the unit itself. Turn off the pressure washer before chang-

ing or adjusting accessories. For cold water use only.

Save these instructions. Refer to them frequently and use

them to instruct other users. If you loan someone this tool,

loan them these instructions also. Do not use this acces-

sory if it appears damaged or if any parts are missing.

WARNING:

To reduce the risk of injection or injury, only use the sur-

face cleaner on flat, horizontal surfaces. Never lift the

surface cleaner from the cleaning surface while operating

the pressure washer.

n Always test in an inconspicuous area first.

n Do not operate in an area for more than 2 seconds or

damage may occur.

PRODUCT SPECIFICATIONS

See Figures 1 and 4.

Connections .............................1/4 in. Quick Connect Plug

Deck Width ................................................................. 12 in.

Maximum Pressure .......................................up to 1800 psi

Maximum Water Flow ................................................2 gpm

Maximum Water Temperature ....................................104°F

RAISING AND LOWERING THE SPRAY BAR

See Figure 1.

Adjust the height of the spray bar by moving the sliding latch

away from the surface cleaner and pulling up or pushing

down on the height adjustment handle. Release the sliding

latch to secure in place.

n Raise the spray bar assembly for delicate surfaces like

wood decks.

n Lower the spray bar assembly for hard surfaces like

concrete, stone, brick, etc.

INSTALLING THE SURFACE CLEANER ON THE

SPRAY WAND

See Figure 2.

Insert the surface cleaner inlet plug into the spray wand quick

connect coupler and secure.

USING THE SURFACE CLEANER

See Figure 3.

n Once the surface cleaner is installed, connect the hose

to the pressure washer as described in your pressure

washer manual.

n Start the pressure washer as described in your pressure

washer manual.

n Walk slowly behind the surface cleaner, cleaning as you go.

Fig. 1

Fig. 2

12 in. Surface Cleaner Attachment

AP31063

HEIGHT

ADJUSTMENT

HANDLE

CARRY

HANDLE

QUICK

CONNECT

COUPLER

SLIDING

LATCH

SURFACE

CLEANER

INLET PLUG

Summary of content (6 pages)

PAGE 1
2 in. Surface Cleaner Attachment AP31063 WARNING: To reduce the risk of injury, user must read and understand the operator’s manual for their pressure washer before using this accessory. To reduce the risk of injury or property damage, spray the pressure stream in a safe direction to ensure proper connection of all accessories before starting any cleaning project. Fits most pressure washers. Ensure compatibility and proper fit before using this accessory.
PAGE 2
NOTE: If striping or swirling occurs, slow your pace. If striping or swirling continues, the surface cleaner nozzle(s) may be clogged. See Nozzle Maintenance for instructions on cleaning the nozzles. WARNING: Striking any raised obstacle while using the surface cleaner will damage the unit. If contact does occur and causes vibration when operating the pressure washer, stop and discontinue use. Continuing to operate the unit could result in serious injury or damage to the unit.
PAGE 3
Accessoire de 304,8 mm (12 po) pour nettoyeur de surface AP31063 AVERTISSEMENT : Pour réduire les risques de blessure, l’utilisateur doit lire et comprendre le manuel d’utilisation de sa laveuse à pression avant de l’utiliser. Pour réduire les risques de blessures ou de dommages matériels, diriger le jet dans une direction sécuritaire pour vérifier que tous les accessoires sont bien branchés avant de commencer le nettoyage. Convient à la plupart des laveuses à pression.
PAGE 4
NOTE: Si des marques ou des tourbillonnements apparaissent, réduire la vitesse de travail. Si le problème persiste, les buses du nettoyeur de surface peuvent être obstruées. Consulter la section sur l’entretien de la buse pour apprendre comment nettoyer les buses. AVERTISSEMENT : Si le nettoyeur de surface heurte un obstacle surélevé, l’unité risque d’être endommagée.
PAGE 5
Accesorio para limpiador de superficie de 304,8 mm (12 pulg.) AP31063 ADVERTENCIA: Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador de la lavadora de presión antes de usar este accesorio. Para reducir el riesgo de lesiones o daños a la propiedad, rocíe el chorro de presión en una dirección segura para asegurar que la conexión de todos los accesorios sea correcta antes de utilizar la unidad. Para la mayoría de las lavadoras de presión.
PAGE 6
NOTA: Si la unidad marca rayas o gira en espiral, reduzca la velocidad. Si la unidad sigue marcando rayas o girando en espiral, la(s) boquilla(s) del limpiador de superficie pueden obstruirse. Consulte la sección de mantenimiento de las boquilas para saber cómo limpiar las boquillas. ADVERTENCIA: Golpear cualquier obstáculo por sobre el nivel del piso con la unidad de limpieza dañará la unidad. Si hay contacto y causa vibración al operar la lavadora de presión, deténgala y suspenda su uso.