Warranty

ManualsBrandsHome Styles ManualsBookcasesThree Shelf 38 in. W x 39 in. H x 16 in. D, Wood and Steel Orleans Shelving Unit

Hardware List

Hex Wrench

1 pc.

Small

Hex Wrench

1 pc.

Part List (in this carton)

Shelf

2 pcs.

Support

2 pcs.

Top

1 pc.

Side Frame

1 pc.

Side Frame

1 pc.

Spring Washer

12 pcs. (+1 extra)

Flat Washer

12 pcs. (+1 extra)

Home Styles Consumer Assistance: www.homestyles-furniture.com,

servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319

88 5061 39

Storage Stand

Stretcher

1 pc.

Tools required for assembly : Phillips screwdriver, Drill, 3/8” Drill Bit, Level

M6x12

Head Cap Bolt

(short)

12 pcs. (+1 extra)

M6x16

Head Cap Bolt

12 pcs. (+1 extra)

M4x32

Wood Screw

6 pcs. (+1 extra)

IMPORTANT NOTE

Carefully remove all the parts from the carton and put

them individually on a soft cloth to prevent scratches

or other damage occurring to the parts.

We have taken great care in the design of this

product and request that you carefully and strictly

follow our assembly instructions to ensure

a completed product as it was designed.

Summary of content (4 pages)

PAGE 1
88 5061 39 Storage Stand IMPORTANT NOTE. Carefully remove all the parts from the carton and put them individually on a soft cloth to prevent scratches or other damage occurring to the parts. We have taken great care in the design of this product and request that you carefully and strictly follow our assembly instructions to ensure a completed product as it was designed. Part List (in this carton) A. Top 1 pc. B. Side Frame 1 pc. C. Side Frame 1 pc. D. Shelf 2 pcs. E. Support 2 pcs. F. Stretcher 1 pc.
PAGE 2
Assembly Instructions 2/4 IMPORTANT * Do not tighten all the Head Cap Bolts until each part is properly assembled. * You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future. * After assembly, item must be level to work properly. Use the included adjustable levelers to level. STEP 1 Place Top (A) upside down on a soft cloth. Attach Side Frames (B) and (C) to Top (A) with Head Cap Bolts (short), tightening the bolts only Head Cap Bolt half way.
PAGE 3
Assembly Instructions 3/4 STEP 3 Attach Supports (E) to unit with Wood Screws. Wood Screw E E STEP 4 Turn the unit over to its’ upright position. To level the unit, adjust the adjustable levelers on the bottom of unit. (See Figure 3) Note: Unit must be level to work properly.
PAGE 4
Assembly Instructions 4/4 Attention! To help reduce the risk of the unit tipping over, the Tipover Restraint must be installed following these instructions exactly! Anchor in wall 3/8” wall hole Bracket on wall Wall Screw Machine Screw Place unit at desired location. Drill a 3/8” hole in wall at the appropriate location. Insert Anchor into the wall hole and attach Bracket with Wall Screw. Attach Bracket at pre-drilled hole at top of unit with Machine Screw.