Use and Care Guide

Customer Service Hotline 1-877-693-PURE

Page 4

Home Master

Reverse Osmosis System Filter Change Instructions

discharge may be accompanied by a harmless

discoloration due to loose carbon.

10. After the trickle runs clear, close the lever on the

RO faucet and allow the system to pressurize. When

the system has pressurized fully it will shut off

automatically, usually in a few minutes.

(IMPORTANT STEP) dry unit thoroughly again,

gently tug on each connection, and check for leaks.

Then open the reserve tank valve slowly. Allow

reserve tank to fill until full, which may take up to 3

hours.

11. When the tank has filled completely, and the

system shuts-off automatically, then close feed

valve and open RO faucet to allow the water to

drain out until it comes to a complete stop. Then

reopen feed valve and allow system to refill again. A

further tank flush may be necessary depending on

initial tank fill level. Finally, if present, open the

inline ball valve feeding the refrigerator/icemaker

VIDEO INSTUCTIONS AVAILABLE:

https://www.theperfectwater.com/Installation-

Instructions.html

System schematics available upon request.

www.ThePerfectWater.com or contact customer service

at 877-693-7873. We will be happy to assist you with

your filter change.

Perfect Water Technologies, Inc.

Version 8

Home Master

Series

Reverse Osmosis System

Filter Change Instructions

Perfect Water Technologies

PAGE 1
Home Master® Reverse Osmosis System Filter Change Instructions Perfect Water Technologies discharge may be accompanied by a harmless discoloration due to loose carbon. 10. After the trickle runs clear, close the lever on the RO faucet and allow the system to pressurize. When the system has pressurized fully it will shut off automatically, usually in a few minutes. (IMPORTANT STEP) dry unit thoroughly again, gently tug on each connection, and check for leaks. Then open the reserve tank valve slowly.
PAGE 2
Home Master® Reverse Osmosis System Filter Change Home Master® Series Reverse Osmosis System Filter Change Instructions Tools Required Tube cutter or Scissors Towel and/or Paper Towels 1. Clear away a workspace under the sink near the location of the Home Master RO System. 2. Close the water valve feeding the Home Master RO, by either closing the Home Master ball valve located on the cold water line, or alternatively, by closing your angle-stop feed water valve clockwise.