Specification

Perfect Water Technologies, INC.
7701 E. Gray Rd. Suite #109 Scottsdale, AZ 85260
1-877-693-7873
[e-mail]
Performance Data Sheet
MODEL #HM-MINI - 1 MICRON CARBON BLOCK
This system has been tested according to NSF/ANSI 42 and 53 for reduction of the contaminate
listed below. The concentration of the indicated contaminate in water entering the system was
reduced to a concentration less than or equal to the permissible limit for water leaving the system,
as specified in NSF/ANSI 42 and 53. While testing was performed under standard laboratory
conditions, actual performance may vary. The Home Master
® MINI System is certified for cyst
reduction and may be used on disinfected waters that may contain filterable cysts.
Performance Data Table
Contaminate Influent challenge
Concentration
Reduction
Requirement
Average Percent
Reduction
Chlorine,
Taste & Odor
2.0 mg/L ± 10%;
2.22 ppm
≥50% 97.3%
Cyst Minimum 50,000/L;
104,457 particles
99.95% 99.95%
Operating Specifications:
Capacity: 1,350 Gallons
Flow Rate: 0.50 GPM (1.89 LPM)
Maximum Pressure: 125 PSIG
Temperature: 35°-100° F (1.66° - 37.77º C)
General Installation/Operation/Maintenance Requirements:
 Note Flow Direction of filter
 Flush new cartridge with 5 gallons of water prior to use and check for leaks
 Install in compliance with state and local laws and regulations
Special Notices:
 The contaminants or other substances removed or reduced by this water treatment system
are not necessarily in your water
 Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system
Warranty Information: Perfect Water Technologies, Inc. (PWT) warrants that the products delivered will be
free from defects in workmanship or materials. Further, the warranty provided herein applies, only when
used within the products specifications and service life, which is one year from the date of installation or 1
years from the date of manufacture whichever occurs first, (at which time the filter must be removed and
replaced with a new one), beyond which Perfect Water Technologies, Inc. (PWT) is absolved of any and all
liability for any use of the product. In the event of a defect or non-conformity, buyer shall promptly notify in
writing, supplying proof-of-purchase dates, installation dates, and will protect and retain the products for
investigation, or is absolved of any and all liability from any use of the product. There are no other
warranties, either of merchantability or fitness, either expressed or implied. Effective as of February 28, 2018
REV1 02-20-2018