Instructions / Assembly

Table Of Contents

Preparing the canopy

Preparing the motor

□ Remove the canopy ring (B) from the canopy (C).

□ Remove the two non-slotted canopy mounting screws

with lock washers (BB) from the canopy (C), and

loosen the slotted canopy mounting screws with lock

washers (BB) on the canopy (C).

□ Remove the canopy (C) from the mounting bracket (A)

by turning the canopy (C) counterclockwise.

Assembling the fan

□ Remove the cotter pin (EE) and clevis pin (DD), and

loosen the two collar setscrews (HH) from the motor

collar.

□ Take out the setscrew (GG) located in the hanger ball

(OO), lower the hanger ball (OO) and remove the

cross pin (FF). Remove the hanger ball (OO) from the

hanger ball/downrod assembly (E).

□ Remove the ground lead (PP) from the downrod

assembly (E).

Assembly — Standard Ceiling Mounting

WARNING: Failure to properly install the cotter pin (EE)

could result in the fan loosening and possibly falling.

□ Carefully feed the motor wires up through the

downrod (QQ). Thread the downrod (QQ) into the

collar.

□ Align the holes and replace the clevis pin (DD) and

cotter pin (EE). Tighten the two collar setscrews (HH).

□ Slip the coupling cover (F), canopy ring (B), and

canopy (C) onto the downrod (QQ).

□ Carefully reinstall the hanger ball (OO) onto the

downrod (QQ) and reinstall the ground lead (PP) onto

the downrod (QQ), being sure that the cross pin (FF)

is in the correct position, the setscrew (GG) is

tightened and wires are not twisted.

NOTE: If a longer downrod (not included) is needed, take out

the screw located in the hanger ball (OO), lower the hanger

ball (OO) and remove the pin (FF). Remove all three pieces

from the downrod and assemble them onto the new longer

downrod before proceeding to the downrod installation.

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.