Instructions / Assembly

Preparing the canopy

Preparing the motor

□ Remove the canopy ring (B) from the canopy (C).

□ Remove the two non-slotted mounting bracket screws

(BB) from the canopy (C), and loosen the slotted

mounting bracket screws (BB) on the canopy (C).

□ Remove the canopy (C) from the mounting bracket (A)

by turning the canopy (C) counterclockwise.

Assembling the fan

□ Remove the cotter pin (GG) and clevis pin (FF), and

loosen the two collar setscrews (JJ) from the motor

collar.

□ Take out the setscrew (II) located in the hanger ball

(QQ), lower the hanger ball (QQ) and remove the

cross pin (HH). Remove the hanger ball (QQ) from the

hanger ball/downrod assembly (E).

Assembly — Standard Ceiling Mounting

WARNING: Failure to properly install the cotter pin (GG)

could result in the fan loosening and possibly falling.

□ Carefully feed the motor wires up through the

downrod (RR). Thread the downrod (RR) into the

collar.

□ Align the holes and replace clevis pin (FF) and cotter

pin (GG). Tighten the two collar setscrews (JJ).

□ Slip the coupling cover (F), canopy ring (B), and

canopy (C) onto the downrod (RR).

□ Carefully reinstall the hanger ball (QQ) onto the

downrod (RR), being sure that the cross pin (HH) is in

the correct position, the setscrew (II) is tightened and

wires are not twisted.

NOTE: If a longer downrod (not included) is needed, take

out the screw located in the hanger ball (QQ), lower the

hanger ball (QQ) and remove the pin (HH). Remove all three

pieces from the downrod and assemble them onto the new

longer downrod before proceeding to the downrod installa-

tion.

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.