Instructions / Assembly

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly

Attaching the table legs

□

Place the tabletop (A) up-side down on a flat, solid surface.

Attach a table leg (C) to the tabletop (A) using the 1/4 in x 20

mm bolts (AA) and washers (CC) as shown in the diagram.

Guide the bolts (AA) through the hole in the table leg (C) into

the pre-drilled hole in the tabletop (A).

Hand tighten three to four turns only. (Do not tighten

completely).

Repeat for the other legs.

Attaching the leg connector bracket

□

Attach a leg (C) to the leg connector bracket (B) by using the

1/4 in x 25 mm bolts (BB) and washers (CC) as shown in the

diagram.

Guide the bolts (BB) through the holes in the leg connector

bracket (B) into the pre-drilled hole in the leg (C).

Hand tighten two to three turns only. (Do not tighten

completely.)

Repeat for the other legs.

Tightening the nuts to the bolts

□

Use the hex bolt driver (DD) to tighten all bolts (AA and BB).

Repeat until all bolts (AA and BB) are tight. (Do not over

tighten. Over tightening may strip bolts.)

Cover all bolts (AA and BB) with covers (DD).

FOOT CAP