Instructions / Assembly

R
3/3
Note: Hat matching cloth colur.
Your Witch Trio is now fully assembled. Plug in and turn on for the fun to begin.
T
T
S
S
U
V
W
G
H
I
7.1
9.1
8.1
Green
I
H
G
Orange
Purple
IR SENSOR
OPERATION INSTRUCTIONS:
1. Plug the AC adapter into a standard power outlet and adjust the settings on the Function Control Box, located on the
(C) Function Control Box Frame.
2. Settings:
Sensor - This switch mode will activate lights, sound, and animation when the Infra-red (IR) sensor is activated and will operate for 1 audio-cycle with each
activation. The Infra-red (IR) sensor has a range of up to 2 m/6.5 ft. and will activate when someone comes within an 80-degree angle from
left-to-right, as well as from above and below.
OFF/TRY ME – This switch mode either turns off the item OR allows the item to be activated only if triggered by
using a Step Here Activation Pad or Try Me Button (both not included). The item will operate for one audio cycle with each Try Me
activation.
I (ON) - This switch mode will continually operate the lights, sound, and animation of the item.
- Raise or lower the volume using the volume control turn dial, turn all the way down to turn the volume off .
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect the equipment
into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or experienced radio/TV technician for help.
CAN ICES-3 (B)/NMB-3 (B)
Sensor / Détecteur
5.9 V
Try Me / Essaie-moi / Pruébame
Sensor / Détecteur
Try Me / Essaie-moi / Pruébame
Be sure nothing is
blocking the sensor.
Distributed by Home Depot
2455 Paces Ferry Road Atlanta, GA 30339
1-877-527-0313