INcjh038_US 824-050 V80 120V~60Hz 45W IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY ASSEMBLY & INSTRUCTION MANUAL
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND.OTHER BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! IMPORTANT SAFETY INFORMATION 1. Read all instructions carefully before using the FAN. 2. Use this FAN only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons. 3.
12. Do not use FAN outdoors. 13. Disconnect the fan from the mains power when not in use, and before servicing or performing any maintenance. WARNING : The Main Power Switch and the On/Off switch should not be used as the sole means of disconnecting power. Always unplug the power cord before servicing or moving the unit. 14. Keep the fan clean and maintain in good condition (use an authorized service agent). 15.
WARNING : PARTS NAME To avoid danger of electric shock, unplug from outlet when not in use and before cleaning. If the supply cord is damaged, it must be replaced by the manufactory or it’s service agent or a similarity qualified person in order to avoid a hazard. ASSEMBLY The base of the tower fan comes in two parts, which fit around the oscillation base. Both parts fit easily together. The back half is the one with cut-outs for the power supply cord. 1.
(Fig 1 ) REMOTE CONTROL 1.Included a button cell battery (the type of battery CR2025). 2.The Remote Control Power button is labeled as such. All the functions performed with the Remote Control work identically to the Manual Controls.
OPERATION The FAN may be operated by the manual controls located on the FAN (as shown in Fig 3) or by your remote control (shown in Fig 2) . 1. Place the FAN on a stable flat surface. Plug the cord set into a 120V~ electrical outlet.Plug on the FAN, existing room temperature will be displayed at display panel. 2. POWER : Turn the FAN on by pressing the ‘POWER’ button; Turn the FAN off by pressing the ‘POWER’ button again. 3.
you don’t control the fan in 30 seconds, touch any button to turn on the display. 6. OSC : Pressing the ‘OSC’ button will start and stop the oscillation function. The symbol is displayed on the LED panel. Aroma box ( Fig 4) 7. Display ( Fig 5) : Can be switched off temporarily by press the LED button on the remote or by pressing and holding the SPEED button on the control panel for more than 3 seconds, the display will light up again once any control button is activated. 8.
MAINTENANCE 1. This can only be done by an authorized service agent such as your local Sealer dealer or any agent qualified to undertake electrical repairs. 2. If the unit requires external cleaning make sure it is switched off and unplugged from the mains supply. Use a soft tissue or cloth for general cleaning. To remove more persistent dirt or grime wipe down with a cloth that has been dampened with warm soapy water. Do not use any solvents ( such as thinners ) as these may damage the plastic casing.
