Owner Manual

Assembly Instructions



�



-

ASSEMBLY RA TING





 

 



O O@@@o1FFICULT



Tools Required For Assembly:







 















2 PERSONS RECOMMENDED

Page 1 of 6

PAGE 1
Assembly Instructions /7 ---- .,,.------+------ � -\ I u ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended. 1 Allen Wrench (Included) t'.
PAGE 2
PAGE 3
#D #C
PAGE 4
2. Insert a screw (#G) into each end of the crossbar (#3). Secure using a Phillips screwdriver. 1. Align the crossbar (#3) to the opening side of the seat frame (#1). 1. Insert 4 threaded rods (#A) into the holes along each arm (#5) and turn right to tighten. 2. Insert the other ends of those threaded rods (#A) into the holes along the sides of the seat frame (#1). 3. Insert a flat washer (#C) then a hex nut (#D) onto the threaded rods (#A) and secure using the wrench (#B).
PAGE 5
1. Align the legs (#6) to the corners along the bottom. 2. Insert a bolt (#E) into each leg (#6) and secure using the Allen wrench. 1. Insert 4 threaded rods (#A) into the holes along the back frame (#4) and turn right to tighten. 2. Insert the other ends of those threaded rods (#A) into the holes along the back. Back 3. Insert a flat washer (#C) then a hex nut (#D) onto the threaded rods (#A) and secure using the wrench (#B).
PAGE 6
Carefully turn the completed table upright. Make sure the table is rested on a flat surface and does not feel loose or wobbly. If it does, double check that the bolts are secured and properly tightened.