Assembly Instructions ASSEMBLY RATING The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in Position each part correctly and insert ~~ Use cardboard or carpet area when an assembly, please make sure the screws or bolts into their respective assembling furniture to prevent lock or spring washer is placed holes by hand tighten or using the scratches .
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Due to the size and/or weight of this product, it is highly recommended that the assembly should be done near the area of its intended location. Make sure you have enough space to move around during the assembly. ALWAYS have at least two people to help with transporting and assembling the product to avoid any potential injury and/or damage. I. Align the leg support (#3) with the per-drilled holes of the right headboard leg (#2R) and the left headboard leg Il.
I. With the help of another person, carefully align the headboard (#1) with the per-drilled holes of the right headboard leg (#2R) and the left headboard leg Il. Prepare 8 bolt assemblies by inserting FIRST the lock washer (#C) onto the bolt (#A) and then the flat washer (#D) onto the SAME bolt in that order. lll.
Align the threaded end of the slat support leg (#7) with the per-drilled hole of the slat (#6) and tighten by hand until secured. Repeat the process for attaching the remaining slat support leg (#7) onto the remaining slats Align the ends of the assembled slat (#6) with the per-drilled holes on each side of the side rails Secure two screws (#J) into each end of the slat (#6) by using a Phillips screwdriver to tighten them down to the side rails Repeat the process for the remaining 3 .