Assembly

HODEDAH ®
www.Hodedah.com
13| Page
Assembly Of Drawers
3
Screw M3.5 x 14mm
12 Pcs.
4
Screw M4 x 32mm
8 Pcs.
8
Handle
2 Pcs.
8
Screw M4 X 20mm
4 Pcs.
(1)
11
Nail
14 Pcs.
(2)
2
M3x16mm Screw
2 Pcs.
10
Backply Stopper
2 Pcs.
x2
-Place panel I and J on each side of panel H
with Panel I and J 's PVC dowel insert to panel
H 's non-thru hole and Panel H 's mini fix screws
insert into Panel I and J 's thru as shown.
Then tighten mini fix on panel I and J clockwise to
lock mini fix up.
-Next tighten screw ④ to panel I and J 's upper
thru holes to fix up to the panel K.
-Flip drawer with
bottom side up, place
panel L onto the
drawer and align
properly. Then nail the
nails provided with
hammer on the border
of panel L as
shown.The gap
between 2 nails is
about 100mm.
-After that, place a
drawer slide B ⑬ with
the small white roller
facing outward and
with other end tip
touching panel H onto
each bottom side
(angle) edge of panel
I and J. Then tighten
3 screws ③ on each
drawer slide B ⑬
(as shown).
Put the backply stopper ⑩ onto
panel L with the shorter part
touching panel H, then tighten
it with screw ②.
-Flip the drawer over.
-Tighten 2 screw ⑧ from inner side of panel H into the handle ⑧ holes.
(3)